AT25DF161 datasheet(35/60 Pages) ATMEL

35 / 60 page

3687C–DFLASH–7/09

AT25DF161 [Preliminary]

11. Status Register Commands

11.1 Read Status Register

The two-byte Status Register can be read to determine the device’s ready/busy status, as well

as the status of many other functions such as Hardware Locking and Software Protection. The

Status Register can be read at any time, including during an internally self-timed program or

erase operation.

To read the Status Register, the CS pin must first be asserted and the opcode of 05h must be

clocked into the device. After the opcode has been clocked in, the device will begin outputting

Status Register data on the SO pin during every subsequent clock cycle. After the second byte

of the Status Register has been clocked out, the sequence will repeat itself starting again with

the first byte of the Status Register as long as the CS pin remains asserted and the clock pin is

being pulsed. The data in the Status Register is constantly being updated, so each repeating

sequence will output new data. The RDY/BSY status is available for both bytes of the Status

At clock frequencies above fCLK, the first two bytes of data output from the Status Register will

not be valid. Therefore, if operating at clock frequencies above fCLK, at least four bytes of data

must be clocked out from the device in order to read the correct values of both bytes of the Sta-

tus Register.

Deasserting the CS pin will terminate the Read Status Register operation and put the SO pin

into a high-impedance state. The CS pin can be deasserted at any time and does not require

that a full byte of data be read.

AT25DF161 bảng dữ liệu(PDF) 35 Page - ATMEL Corporation