SH7721 datasheet(256/1524 Pages) RENESAS

256 / 1524 page

Section 4 Memory Management Unit (MMU)

Rev. 3.00 Jan. 18, 2008 Page 194 of 1458

REJ09B0033-0300

4.6

Memory-Mapped TLB

In order for TLB operations to be managed by software, TLB contents can be read or written to in

the privileged mode using the MOV instruction. The TLB is assigned to the P4 area in the virtual

address space. The TLB address array (VPN, V bit, and ASID) is assigned to H'F200 0000 to

H'F2FF FFFF, and the data array (PPN, PR, SZ, C, D, and SH bits) to H'F300 0000 to H'F3FF

FFFF. The V bit in the address array can also be accessed from the data array. Only longword

access is possible for both the address array and the data array. However, the instruction data

cannot be fetched from both arrays.

4.6.1

Address Array

The address array is assigned to H'F200 0000 to H'F2FF FFFF. To access an address array, the 32-

bit address field (for read/write operations) and 32-bit data field (for write operations) must be

specified. The address field specifies information for selecting the entry to be accessed; the data

field specifies the VPN, V bit and ASID to be written to the address array (figure 4.14 (1)).

In the address field, specify the entry address for selecting the entry (bits 16 to 12), W for

selecting the way (bits 9 to 8) and H

′F2 to indicate address array access (bits 31 to 24). The IX bit

in MMUCR indicates whether an EX-OR is taken of the entry address and ASID.

The following two operations can be used on the address array:

1. Address array read

VPN, V, and ASID are read from the TLB entry corresponding to the entry address and way

set in the address field.

2. TLB address array write

The data specified in the data field are written to the TLB entry corresponding to the entry

address and way set in the address field.

4.6.2

Data Array

The data array is assigned to H'F300 0000 to H'F3FF FFFF. To access a data array, the 32-bit

address field (for read/write operations), and 32-bit data field (for write operations) must be

specified. The address section specifies information for selecting the entry to be accessed; the data

section specifies the longword data to be written to the data array (figure 4.14 (2)).

In the address section, specify the entry address for selecting the entry (bits 16 to 12), W for

selecting the way (bits 9 to 8), and H'F3 to indicate data array access (bits 31 to 24). The IX bit in

MMUCR indicates whether an EX-OR is taken of the entry address and ASID.

SH7721 bảng dữ liệu(PDF) 256 Page - Renesas Technology Corp