SH7713 datasheet(219/904 Pages) RENESAS

219 / 904 page

Section 4 Exception Handling

Rev.1.50 Aug. 30, 2006 Page 179 of 860

REJ09B0288-0150

MMU Exception in Repeat Control Period: If an MMU exception occurs in the repeat control

period, a specific exception code is generated as well as a CPU address error. For a TLB miss

exception, TLB invalid exception, and initial page write exception, an exception code (H

′070) is

specified in the EXPEVT. For a TLB protection exception, an exception code (H

′0D0) is specified

in the EXPEVT. In a TLB miss exception, vector offset is specified as H

′00000100.

An instruction where an exception occurs and the SPC value to be saved are the same as those for

the CPU address error.

After this exception processing, the repeat control cannot be returned correctly. To execute a

repeat loop correctly, care must be taken not to generate an MMU related exception in the repeat

control period.

Note:

In a repeat loop consisting of one to three instructions, some restrictions apply to repeat

detection instructions and all the remaining instructions. In a repeat loop consisting of four

or more instructions, restrictions apply to only the four instructions that include a repeat

end instruction. The restriction occurs when SR.RC[11:0]

≥ 1.

4.5

Usage Notes

An instruction assigned at a delay slot of the RTE instruction is executed after the contents of

the SSR is restored into the SR. An acceptance of an exception related to instruction access is

determined according to the SR before restore. An acceptance of other exceptions is

determined by processing mode of the SR after restore, and BL bit value. A processing-

completion type exception is accepted before an instruction at the RTE branch destination

address is executed. However, note that the correct operation cannot be guaranteed if a re-

execution type exception occurs.

In an instruction assigned at a delay slot of the RTE instruction, a user break cannot be

accepted.

If the MD and BL bits of the SR register are changed by the LDC instruction, an exception is

accepted according to the changed SR value from the next instruction.* A processing-

completion type exception is accepted after the next instruction is executed. An interrupt and

DMA address error in re-execution type exceptions are accepted before the next instruction is

executed.

Note: * If an LDC instruction is executed for the SR, the following instructions are re-fetched

and an instruction fetch exception is accepted according to the modified SR value.

SH7713 bảng dữ liệu(PDF) 219 Page - Renesas Technology Corp