SH7713 datasheet(201/904 Pages) RENESAS

201 / 904 page

Section 4 Exception Handling

Rev.1.50 Aug. 30, 2006 Page 161 of 860

REJ09B0288-0150

If a general exception other than a DMA address error or user break occurs while the BL bit is set

to 1, the CPU enters a state similar to that in effect immediately after a reset, and passes control to

the reset vector (H

′A0000000) (multiple exception). In this case, unlike a normal reset, modules

other than the CPU are not initialized, the contents of EXPEVT, SPC, and SSR are undefined, and

this status is not detected by an external device.

To enable acceptance of multiple exceptions, the contents of SPC and SSR must be saved while

the BL bit is set to 1 after an exception has been accepted, and then the BL bit must be cleared to

0. Before restoring the SPC and SSR, the BL bit must be set to 1.

4.2.5

Exception Source Acceptance Timing and Priority

Exception Request of Instruction Synchronous Type and Instruction Asynchronous Type:

Resets and interrupts are requested asynchronously regardless of the program flow. In general

exceptions, a DMA address error and a user break under the specific condition are also requested

asynchronously. The user cannot expect on which instruction an exception is requested. For

general exceptions other than a DMA address error and a user break under a specific condition,

each general exception corresponds to a specific instruction.

Re-Execution Type and Processing-Completion Type Exceptions: All exceptions are classified

into two types: a re-execution type and a processing-completion type. If a re-execution type

exception is accepted, the current instruction executed when the exception is accepted is

terminated and the instruction address is saved to the SPC. After returning from the exception

processing, program execution resumes from the instruction where the exception was accepted. In

a processing-completion type exception, the current instruction executed when the exception is

accepted is completed, the next instruction address is saved to the SPC, and then the exception

processing is executed.

During a delayed branch instruction and delay slot, the following operations are executed. A re-

execution type exception detected in a delay slot is accepted before executing the delayed branch

instruction. A processing-completion type exception detected in a delayed branch instruction or a

delay slot is accepted when the delayed branch instruction has been executed. In this case, the

acceptance of delayed branch instruction or a delay slot precedes the execution of the branch

destination instruction. In the above description, a delay slot indicates an instruction following an

unconditional delayed branch instruction or an instruction following a conditional delayed branch

instruction whose branch condition is satisfied. If a branch does not occur in a conditional delayed

branch, the normal processing is executed.

SH7713 bảng dữ liệu(PDF) 201 Page - Renesas Technology Corp