công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

PCA9527DPZ bảng dữ liệu(PDF) 6 Page - NXP Semiconductors

tên linh kiện PCA9527DPZ
Giải thích chi tiết về linh kiện  3-channel bidirectional bus extender for HDMI
PDF  23 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
nhà sản xuất  NXP [NXP Semiconductors]
Trang chủ  http://www.nxp.com
Logo NXP - NXP Semiconductors

PCA9527DPZ bảng dữ liệu(HTML) 6 Page - NXP Semiconductors

Back Button PCA9527DPZ Datasheet HTML 2Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 3Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 4Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 5Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 6Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 7Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 8Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 9Page - NXP Semiconductors PCA9527DPZ Datasheet HTML 10Page - NXP Semiconductors Next Button
Zoom Inzoom in Zoom Outzoom out
 6 / 23 page
background image
NXP Semiconductors
PCA9527
3-channel bidirectional bus extender for HDMI, I2C-bus and SMBus
Pin
Where
Minimum
Maximum
at the sink (LCD TV)
-
-
at the source (DVD/STB)
1.5 kΩ
2.0 kΩ
SCLA
at the sink (LCD TV)
47 kΩ ± 10 %
Table 4. HDMI DDC pull-up resistors specification...continued
CL (nF)
0
4.0
3.0
2.0
1.0
002aad620
4.5
6.5
2.5
8.5
10.5
RPU
(kΩ)
0.5
does not comply with
1 µs rise time
complies with
1 µs rise time
rise time = 1 μs; VCC(A) = 5 V
Figure 4. SDAA/SCLA line pull-up resistor versus load capacitance
6.3.2 Port A (CECA)
CECA does not have a rise time accelerator, but has a standard open-drain I/O. In
addition to incurring no offset voltage, it has edge rate control and a lower capacitance
than those of standard discrete MOSFET, and isolates the input/output capacitance. It is
designed for a lower speed channel for consumer electronic control (less than 10 kHz) or
general purpose interrupt or reset over long cable.
CECA does not have internal pull-up. The pull-up resistor is calculated using standard
I2C-bus pull-up resistor formula, as shown in Section 6.3.3CECB)".
6.3.3 Port B (SDAB, SCLB, CECB)
SDAB and SCLB are standard I2C-bus with static level offset that has no rise time
accelerator. The static level offset produces an output LOW of 0.5 V (typical) at 6 mA.
As with the standard I2C-bus system, pull-up resistors are required to provide the logic
HIGH levels. The size of these pull-up resistors depends on the system requirement, and
should meet the current sinking capability of the device that drives the buffer, as well as
that of the buffer. The minimum and maximum pull-up resistors are determined and the
pull-up resistor’s value is chosen to be within the minimum and maximum range.
Using Equation 1, calculate the minimum pull-up resistor value:
(1)
Where:
RPU(min) is the minimum pull-up resistor value for the open-drain SCLB and SDAB.
PCA9527
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2021. All rights reserved.
Product data sheet
Rev. 1.1 — 20 August 2021
6 / 23



Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23


bảng dữ liệu tải về

Go To PDF Page


Link URL



Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không?  [ DONATE ] 

Alldatasheet là   |   Quảng cáo   |   Liên lạc với chúng tôi   |   Chính sách bảo mật   |   Liên kết đến bảng dữ liệu    |   Trao đổi link   |   Tìm kiếm theo nhà sản xuất
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com