NRF52811-QCAA-R7 datasheet(192/444 Pages) NORDIC

192 / 444 page

Peripherals

TXRU

TXIDLE

S0 L S1

PAYLOAD

CRC

TXIDLE

TXDISABLE

(carrier)

CTE

Figure 75: Transmit sequence with DFE

The prescence of CTE within a received packet is signalled by the CTEPRESENT and CTEWARNING events

illustrated in the figure below.

RXRU

RXIDLE

S0 L S1

PAYLOAD

CRC

RXIDLE

RXDISABLE

’X’

CTE

Figure 76: Receive sequence with DFE

6.14.12.6 Antenna switching

The RADIO can control up to 8 GPIO pins in order to control external antenna switches used in direction

finding.

Pin configuration

The eight antenna selection signals are mapped to physical pins according to the pin numbers specified

in the PSEL.DFEGPIO[n] registers. Only pins that have the PSEL.DFEGPIO[n].CONNECTED field set to

Connected will be controlled by the RADIO. Pins that are Disconnected will be controlled by GPIO.

During transmission in AoD TX mode or reception in AoA RX mode, the RADIO automatically acquires the

pins as needed. At times when the RADIO does not use the pin, the pin is released to its default state and

controlled by the GPIO configuration. Thus, the pin must be configured using the GPIO peripheral.

Pin acquired by RADIO

Direction

Value

Comment

Yes

Output

Specified in SWITCHPATTERN Pin acquired by RADIO, and in use for DFE.

Specified by GPIO

DFE not in progress. Pin has not been acquired by RADIO, but is available for

DFE use.

Table 63: Pin configuration matrix for a connected and enabled pin [n]

4454_140 v1.0

192

NRF52811-QCAA-R7 bảng dữ liệu(PDF) 192 Page - Nordic Semiconductor

NRF52811-QCAA-R7 bảng dữ liệu(HTML) 192 Page - Nordic Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL