GP32SLASH2 datasheet(23/44 Pages) CLARKE

23 / 44 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

TO DRAIN THE CARBURETTOR

1. Loosen the right maintenance cover

knobs, and remove the cover from

the side panel.

2. Turn the Main Switch to the Start/

Run position.

3. Remove the battery.

4. Prepare an approved petrol storage

container and position it directly

under the carburettor drain screw

to catch the fuel.

5. Loosen the drain screw.

6. Allow the fuel to drain completely into the container.

7. Retighten the drain screw securely.

8. Turn the Main switch to the Off position.

9. Reinstall the maintenance cover

NOTE: Make sure to drain the carburettor before storing the generator for long

periods of time.

DRAINING/CHANGING THE OIL

Change the oil more often if operating under heavy load or high ambient

temperature. It is also necessary to drain the oil from the crankcase if it has become

contaminated with water or dirt. Changing the oil when the engine is warm allows for

complete drainage. Change the oil according to the recommended maintenance

schedule on page 19.

TO CHANGE THE ENGINE OIL:

1. With the help of another person, place the generator on an elevated platform such

as a table or workbench.

2. Loosen the screws of the left hand

side maintenance cover, and remove

the cover from the side panel.

3. Place a suitable container underneath

the generator to catch the used oil.

GP32/2 bảng dữ liệu(PDF) 23 Page - Clarke International