C8051F310 datasheet(167/228 Pages) SILABS

167 / 228 page

Rev. 1.7

167

C8051F310/1/2/3/4/5/6/7

15.3. Multiprocessor Communications

9-Bit UART mode supports multiprocessor communication between a master processor and one or more

slave processors by special use of the ninth data bit. When a master processor wants to transmit to one or

more slaves, it first sends an address byte to select the target(s). An address byte differs from a data byte

in that its ninth bit is logic 1; in a data byte, the ninth bit is always set to logic 0.

Setting the MCE0 bit (SCON0.5) of a slave processor configures its UART such that when a stop bit is

received, the UART will generate an interrupt only if the ninth bit is logic 1 (RB80 = 1) signifying an address

byte has been received. In the UART interrupt handler, software will compare the received address with

the slave's own assigned 8-bit address. If the addresses match, the slave will clear its MCE0 bit to enable

interrupts on the reception of the following data byte(s). Slaves that weren't addressed leave their MCE0

bits set and do not generate interrupts on the reception of the following data bytes, thereby ignoring the

data. Once the entire message is received, the addressed slave resets its MCE0 bit to ignore all transmis-

sions until it receives the next address byte.

Multiple addresses can be assigned to a single slave and/or a single address can be assigned to multiple

slaves, thereby enabling "broadcast" transmissions to more than one slave simultaneously. The master

processor can be configured to receive all transmissions or a protocol can be implemented such that the

master/slave role is temporarily reversed to enable half-duplex transmission between the original master

and slave(s).

Figure 15.6. UART Multi-Processor Mode Interconnect Diagram

Master

Device

Slave

Device

Slave

Device

Slave

Device

V+

C8051F310 bảng dữ liệu(PDF) 167 Page - Silicon Laboratories