| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
TCAN337/G bảng dữ liệu(PDF) 9 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
TCAN337/G bảng dữ liệu(HTML) 9 Page - Texas Instruments |
|
9 / 47 page ![]() 5.6 Switching Characteristics over operating free-air temperature range (unless otherwise noted) PARAMETER TEST CONDITIONS MIN TYP MAX UNIT Device Switching Characteristics tPROP(LOOP) Total loop delay, driver input (TXD) to receiver output (RXD), recessive to dominant and dominant to recessive See Figure 6-6, S, STB and SHDN = 0V, RL = 60Ω, CL = 100pF, CL(RXD) = 15pF 100 135 ns tPROP(LOOP) Total Loop delay in highly loaded network See Figure 6-6, S, STB and SHDN = 0V, RL = 120Ω, CL = 200pF, CL(RXD) = 15pF 120 180 ns tBUS_SYM_2 2 Mbps transmitted recessive bit width See Figure 6-7, S or STB = 0V, RL = 60Ω, C L = 100pF, CL(RXD) = 15 pF, tBIT = 500ns TCAN330G, TCAN332G, TCAN334G and TCAN337G only 435 530 ns tREC_SYM_2 2 Mbps received recessive bit width 400 550 ns ΔtSYM_2 2 Mbps receiver timing symmetry (tREC_SYM_2 - tBUS_SYM_2) –65 40 ns tBUS_SYM_5 5 Mbps transmitted recessive bit width See Figure 6-7, S or STB = 0V, RL = 60Ω, C L = 100pF, CL(RXD) = 15pF, tBIT = 200ns TCAN330G, TCAN332G, TCAN334G and TCAN337G only 155 210 ns tREC_SYM_5 5 Mbps received recessive bit width 120 220 ns ΔtSYM_5 5 Mbps receiver timing symmetry (tREC_SYM_5 - tBUS_SYM_5) –45 15 ns tMODE Mode change time See Figure 6-4 and Figure 6-5. RL = 60Ω, CL = 100pF, CL(RXD) = 15pF 5 10 µs tUV_RE-ENABLE Re-enable time after UV event Time for device to return to normal operation from UV(VCC) under voltage event 1000 µs tWK_FILTER Bus time to meet Filtered Bus Requirements for Wake Up Request See Figure 6-5, Standby mode. –12V < VCM < 12V 0.5 4 µs Driver Switching Characteristics tpHR Propagation delay time, HIGH TXD to Driver Recessive See Figure 6-2, S, STB and SHDN = 0V. RL = 60Ω, CL = 100pF, 25 ns tpLD Propagation delay time, LOW TXD to Driver Dominant 20 tsk(p) Pulse skew (|tpHR - tpLD|) 5 tr Differential output signal rise time 17 tf Differential output signal fall time 9 tTXD_DTO Driver dominant time out (1) See Figure 6-8, RL = 60Ω, CL = 100pF 1.2 2.6 3.8 ms Receiver Switching Characteristics tpRH Propagation delay time, bus recessive input to high RXD output See Figure 6-3, CL(RXD) = 15pF CANL = 1.5V, CANH = 3.5V 62 ns tpDL Propagation delay time, bus dominant input to RXD low output 56 tr Output signal rise time (RXD) 7 tf Output signal fall time (RXD) 6 tRXD_DTO Receiver dominant time out (2) See Figure 6-10, CL(RXD) = 15pF 1.6 3 5 ms (1) The TXD dominant time out (tTXD_DTO) disables the driver of the transceiver once the TXD has been dominant longer than tTXD_DTO, which releases the bus lines to recessive, preventing a local failure from locking the bus dominant. The driver may only transmit dominant again after TXD has been returned HIGH (recessive). While this protects the bus from local faults, locking the bus dominant, it limits the minimum data rate possible. The CAN protocol allows a maximum of eleven successive dominant bits (on TXD) for the worst case, where five successive dominant bits are followed immediately by an error frame. This, along with the tTXD_DTO minimum, limits the minimum bit rate. The minimum bit rate may be calculated by: Minimum Bit Rate = 11/ tTXD_DTO = 11 bits / 1.2 ms = 9.2kbps. (2) The RXD timeout (tRXD_DTO) disables the RXD output in the case that the bus has been dominant longer than tRXD_DTO, which releases RXD pin to the recessive state (high), thus preventing a dominant bus failure from permanently keeping the RXD pin low. The RXD pin will automatically resume normal operation once the bus has been returned to a recessive state. While this protects the protocol controller from a permanent dominant state, it limits the minimum data rate possible. The CAN protocol allows a maximum of eleven successive dominant bits (on RXD) for the worst case, where five successive dominant bits are followed immediately by an error frame. This, along with the tRXD_DTO minimum, limits the minimum bit rate. The minimum bit rate may be calculated by: Minimum Bit Rate = 11 / tRXD_DTO = 11 bits / 1.6ms = 6.9kbps. www.ti.com TCAN330, TCAN332, TCAN334, TCAN337 TCAN330G, TCAN332G, TCAN334G, TCAN337G SLLSEQ7F – DECEMBER 2015 – REVISED MAY 2025 Copyright © 2025 Texas Instruments Incorporated Submit Document Feedback 9 Product Folder Links: TCAN330 TCAN332 TCAN334 TCAN337 TCAN330G TCAN332G TCAN334G TCAN337G |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |