SPSB100 datasheet(67/213 Pages) STMICROELECTRONICS

67 / 213 page

Table 20. Safety requirement list while MCU is in Smart-Power mode

Description

Safe state

SR1

While MCU is in Smart-Power mode the PMIC

shall monitor the supply output voltages for the

MCU and force a reset of the MCU in case of a

voltage error.

Output regulators are stopped, NRESET and NFSO pins are

asserted. SPSB100 tries to power-up again, if the fault is confirmed

for 3 successive power-up then output regulators are stopped,

NRESET and NFSO pins are asserted and SPSB100 reaches

DEEP-SLEEP state.

SR2

The PMIC shall monitor the local temperature of

each supply regulator and force a shut-down of

the supply regulator in case of temperature

runaway.

Output regulators are stopped, NRESET and NFSO pins are

asserted. SPSB100 waits that the regulator temperature decreases

then tries to power-up again, if the fault is confirmed for 3

successive power-up then output regulators are stopped, NRESET

and NFSO pins are asserted and SPSB100 reaches DEEP-SLEEP

state.

SR3

The PMIC shall monitor the power dissipation of

BOOST external transistors and avoid their

destruction in case of runaway.

BOOST is stopped, error is signaled to MCU, SPSB100 state is

unchanged.

Note:

More details about functional safety can be found in the device safety manual, provided only upon customers

request.

6.1.3

MCU in Stand-by mode

The following figure shows MCU in Stand-by mode.

Figure 40. PMIC + MCU in Stand-By mode

SPSB100

Functional safety concept

DS14640 - Rev 2

page 67/213

SPSB100 bảng dữ liệu(PDF) 67 Page - STMicroelectronics