AMC1306M25 datasheet(22/45 Pages) TI2

22 / 45 page

Frequency (kHz)

0.1

100

1000

10000

-160

-140

-120

-100

-80

-60

-40

-20

D007

AMC1306E05, AMC1306E25, AMC1306M05, AMC1306M25

SBAS734C – MARCH 2017 – REVISED JANAURY 2020

www.ti.com

Product Folder Links: AMC1306E05 AMC1306E25 AMC1306M05 AMC1306M25

Submit Documentation Feedback

8.3 Feature Description

8.3.1 Analog Input

The AMC1306 incorporates front-end circuitry that contains a differential amplifier and a sampling stage, followed

by a ΔΣ modulator. The gain of the differential amplifier is set by internal precision resistors to a factor of 4 for

devices with a specified input voltage range of ±250 mV (this value is for the AMC1306x25), or to a factor of 20

in devices with a ±50-mV input voltage range (for the AMC1306x05), resulting in a differential input impedance of

4.9 kΩ (for the AMC1306x05) or 22 kΩ (for the AMC1306x25). For reduced offset and offset drift, the differential

amplifier is chopper-stabilized with the switching frequency set at fCLKIN / 32. The switching frequency generates

a spur as shown in Figure 47.

sinc3 filter, OSR = 2, fCLKIN = 20 MHz, fIN = 1 kHz

Figure 47. Quantization Noise Shaping

Consider the input impedance of the AMC1306 in designs with high-impedance signal sources that can cause

degradation of gain and offset specifications. The importance of this effect, however, depends on the desired

system performance. Additionally, the input bias current caused by the internal common-mode voltage at the

output of the differential amplifier is dependent on the actual amplitude of the input signal; see the Isolated

Voltage Sensing section for more details on reducing these effects.

There are two restrictions on the analog input signals (AINP and AINN). First, if the input voltage exceeds the

range AGND – 6 V to AVDD + 0.5 V, the input current must be limited to 10 mA because the device input

electrostatic discharge (ESD) diodes turn on. In addition, the linearity and noise performance of the device are

ensured only when the differential analog input voltage remains within the specified linear full-scale range (FSR),

that is ±250 mV (for the AMC1306x25) or ±50 mV (for the AMC1306x05), and within the specified input common-

mode range.

AMC1306M25 bảng dữ liệu(PDF) 22 Page - Texas Instruments