C8051F360 datasheet(90/288 Pages) SILABS

90 / 288 page

C8051F360/1/2/3/4/5/6/7/8/9

Rev. 1.0

9.4.6.3. SFR Page Stack Example

The following is an example that shows the operation of the SFR Page Stack during interrupts.

In this example, the SFR Page Control is left in the default enabled state (i.e., SFRPGEN = 1), and the

CIP-51 is executing in-line code that is writing values to OSCICN (SFR “OSCICN”, located at address

0xB6 on SFR Page 0x0F). The device is also using the Programmable Counter Array (PCA) and the 10-bit

ADC (ADC0) window comparator to monitor a voltage. The PCA is timing a critical control function in its

interrupt service routine (ISR), so its interrupt is enabled and is set to high priority. The ADC0 is monitoring

a voltage that is less important, but to minimize the software overhead its window comparator is being used

with an associated ISR that is set to low priority. At this point, the SFR page is set to access the OSCICN

SFR (SFRPAGE = 0x0F). See Figure 9.4 below.

0x0F

(OSCICN)

SFRPAGE

SFRLAST

SFRNEXT

SFR Page

Stack SFR's

Figure 9.4. SFR Page Stack While Using SFR Page 0x0F To Access OSCICN

While CIP-51 executes in-line code (writing values to OSCICN in this example), ADC0 Window Compara-

tor Interrupt occurs. The CIP-51 vectors to the ADC0 Window Comparator ISR and pushes the current

SFR Page value (SFR Page 0x0F) into SFRNEXT in the SFR Page Stack. SFR page 0x00 is then auto-

matically placed in the SFRPAGE register. SFRPAGE is considered the “top” of the SFR Page Stack. Soft-

ware can now access the ADC0 SFR’s. Software may switch to any SFR Page by writing a new value to

the SFRPAGE register at any time during the ADC0 ISR to access SFR’s that are not on SFR Page 0x00.

See Figure 9.5 below.

C8051F360 bảng dữ liệu(PDF) 90 Page - Silicon Laboratories