CS4360

36

DS517F2

7.

PARAMETER DEFINITIONS

Total Harmonic Distortion + Noise (THD+N)

The ratio of the RMS value of the signal to the RMS sum of all other spectral components over the spec-

ified bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.

Dynamic Range

The ratio of the full-scale RMS value of the signal to the RMS sum of all other spectral components over

the specified bandwidth. Dynamic range is a signal-to-noise measurement over the specified bandwidth

made with a -60 dBFS signal. 60 dB is then added to the resulting measurement to refer the measurement

to full scale. This technique ensures that the distortion components are below the noise level and do not

affect the measurement. This measurement technique has been accepted by the Audio Engineering So-

ciety, AES17-1991, and the Electronic Industries Association of Japan, EIAJ CP-307.

Interchannel Isolation

A measure of crosstalk between the left and right channels. Measured for each channel at the converter's

output with all zeros to the input under test and a full-scale signal applied to the other channel. Units in

decibels.

Interchannel Gain Mismatch

The gain difference between left and right channels. Units in decibels.

Gain Error

The deviation from the nominal full-scale analog output for a full-scale digital input.

Gain Drift

The change in gain value with temperature. Units in ppm/°C.

8.

REFERENCES

1) CDB4360 Evaluation Board Datasheet

2) “The I²C Bus Specification: Version 2.1” Philips Semiconductors, January 2000.

http://www.semiconductors.philips.com