| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
PIC18F4331 bảng dữ liệu(PDF) 87 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
PIC18F4331 bảng dữ liệu(HTML) 87 Page - Microchip Technology |
|
87 / 400 page ![]() © 2007 Microchip Technology Inc. Preliminary DS39616C-page 85 PIC18F2331/2431/4331/4431 EXAMPLE 6-3: WRITING TO FLASH PROGRAM MEMORY (CONTINUED) 6.5.2 WRITE VERIFY Depending on the application, good programming practice may dictate that the value written to the memory should be verified against the original value. This should be used in applications where excessive writes can stress bits near the specification limit. 6.5.3 UNEXPECTED TERMINATION OF WRITE OPERATION If a write is terminated by an unplanned event, such as loss of power or an unexpected Reset, the memory location just programmed should be verified and reprogrammed if needed. The WRERR bit is set when a write operation is interrupted by a MCLR Reset, or a WDT Time-out Reset during normal operation. In these situations, users can check the WRERR bit and rewrite the location. 6.6 Flash Program Operation During Code Protection See Section 22.5 “Program Verification and Code Protection” for details on code protection of Flash program memory. TABLE 6-2: REGISTERS ASSOCIATED WITH PROGRAM FLASH MEMORY PROGRAM_MEMORY BCF INTCON, GIE ; disable interrupts MOVLW 55h ; required sequence MOVWF EECON2 ; write 55H MOVLW 0AAh MOVWF EECON2 ; write 0AAH BSF EECON1, WR ; start program (CPU stall) NOP BSF INTCON, GIE ; re-enable interrupts DECFSZ COUNTER_HI ; loop until done GOTO PROGRAM_LOOP BCF EECON1, WREN ; disable write to memory Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Value on: POR, BOR Value on all other Resets TBLPTRU — —bit 21(1) Program Memory Table Pointer Upper Byte (TBLPTR<20:16>) --00 0000 --00 0000 TBPLTRH Program Memory Table Pointer High Byte (TBLPTR<15:8>) 0000 0000 0000 0000 TBLPTRL Program Memory Table Pointer Low Byte (TBLPTR<7:0>) 0000 0000 0000 0000 TABLAT Program Memory Table Latch 0000 0000 0000 0000 INTCON GIE/GIEH PEIE/GIEL TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF 0000 000x 0000 000u EECON2 EEPROM Control Register 2 (not a physical register) 0000 0000 0000 0000 EECON1 EEPGD CFGS — FREE WRERR WREN WR RD xx-0 x000 uu-0 u000 IPR2 OSCFIP — —EEIP —LVDIP — CCP2IP 1--1 -1-1 1--1 -1-1 PIR2 OSCFIF — — EEIF —LVDIF — CCP2IF 0--0 -0-0 0--0 -0-0 PIE2 OSCFIE — —EEIE —LVDIE — CCP2IE 0--0 -0-0 0--0 -0-0 Legend: x = unknown, u = unchanged, - = unimplemented, read as ‘0’. Shaded cells are not used during Flash/EEPROM access. Note 1: Bit 21 of the PC is only available in Test mode and Serial Programming modes. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |