AD9914SLASHPCBZ datasheet(19/48 Pages) AD

tên linh kiện	AD9914/PCBZ

Giải thích chi tiết về linh kiện	3.5 GSPS Direct Digital Synthesizer with 12-Bit DAC

PDF	48 Pages

Scroll/Zoom	100%

nhà sản xuất	AD [Analog Devices]

Trang chủ	http://www.analog.com

Logo

19 / 48 page

Data Sheet

AD9914

THEORY OF OPERATION

analog.com

Rev. G | 19 of 48

Table 6. Data Source Priority

Priority

DDS Signal Control Parameters

Data Source

Conditions

If output phase offset control is desired, enable profile mode and use the profile registers and profile pins

accordingly to control output phase adjustment.

If output amplitude control is desired, enable profile mode and use the profile registers and profile pins

accordingly to control output amplitude adjustment. Note that the OSK enable bit must be set to control the

output amplitude.

DRG

The digital ramp modulation mode is the next highest priority mode. If the DRG is enabled to sweep output

frequency, phase, or amplitude, the two parameters not being swept can be controlled independently via the

profile mode.

Profiles

The profile modulation mode is the next highest priority mode. Profile mode can control all three parameters

independently, if desired.

Lowest Priority

Parallel port

Parallel data port modulation has the lowest priority but the most flexibility as far as changing any parameter at

the high rate. See the Programming and Function Pins section.

AD9914/PCBZ bảng dữ liệu(PDF) 19 Page - Analog Devices