TLV9151 datasheet(24/60 Pages) TI1

24 / 60 page

6.3.7 Overload Recovery

Overload recovery is defined as the time required for the op amp output to recover from a saturated state to

a linear state. The output devices of the op amp enter a saturation region when the output voltage exceeds

the rated operating voltage, either due to the high input voltage or the high gain. After the device enters the

saturation region, the charge carriers in the output devices require time to return back to the linear state. After

the charge carriers return back to the linear state, the device begins to slew at the specified slew rate. Thus, the

propagation delay in case of an overload condition is the sum of the overload recovery time and the slew time.

The overload recovery time for the TLV915x-Q1 is approximately 400 ns.

6.3.8 Typical Specifications and Distributions

Designers often have questions about a typical specification of an amplifier to design a more robust circuit. Due

to natural variation in process technology and manufacturing procedures, every specification of an amplifier will

exhibit some amount of deviation from the ideal value, like an amplifier's input offset voltage. These deviations

often follow Gaussian (bell curve), or normal distributions, and circuit designers can leverage this information to

guardband their system, even when there is not a minimum or maximum specification in Section 5.7.

0.00002%

-1

-21

-31

-41

-51

-61

+21

+31

+41

+51

+61

34.13% 13.59%

34.13%

13.59%

2.145%

2.145% 0.13185%

0.13185%

0.00312%

Figure 6-9. Ideal Gaussian Distribution

Figure 6-9 shows an example distribution, where µ, or mu, is the mean of the distribution, and where σ,

or sigma, is the standard deviation of a system. For a specification that exhibits this kind of distribution,

approximately two-thirds (68.26%) of all units can be expected to have a value within one standard deviation, or

one sigma, of the mean (from µ – σ to µ + σ).

Depending on the specification, values listed in the typical column of Section 5.7 are represented in different

ways. As a general rule, if a specification naturally has a nonzero mean (for example, like gain bandwidth), then

the typical value is equal to the mean (µ). However, if a specification naturally has a mean near zero (like input

offset voltage), then the typical value is equal to the mean plus one standard deviation (µ + σ) to most accurately

represent the typical value.

TLV9151-Q1, TLV9152-Q1, TLV9154-Q1

SBOSA23G – MAY 2020 – REVISED MARCH 2024

www.ti.com

Submit Document Feedback

Product Folder Links: TLV9151-Q1 TLV9152-Q1 TLV9154-Q1

TLV9151 bảng dữ liệu(PDF) 24 Page - Texas Instruments

TLV9151 bảng dữ liệu(HTML) 24 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

bảng dữ liệu tải về

Link URL