AT83SND2CMP3B datasheet(200/241 Pages) ATMEL

200 / 241 page

200

4341F–MP3–03/06

AT8xC51SND2C/MP3B

Figure 22-2. Timing Diagram

22.1.1

Clock Generator

The ADC clock is generated by division of the peripheral clock (see details in section “X2 Fea-

ture”, page 14). The division factor is then given by ADCP4:0 bits in ADCLK register. Figure 22-

3 shows the ADC clock generator and its calculation formula

(1).

Figure 22-3. ADC Clock Generator and Symbol Caution:

Note:

1. In all cases, the ADC clock frequency may be higher than the maximum F

ADCLK parameter

reported in the section “Analog to Digital Converter”, page 202.

2. The ADCD value of 0 is equivalent to an ADCD value of 32.

22.1.2

Channel Selection

The channel on which conversion is performed is selected by the ADCS bit in ADCON register

according to Table 2.

Table 2. ADC Channel Selection

22.1.3

Conversion Precision

The 10-bit precision conversion is achieved by stopping the CPU core activity during conversion

for limiting the digital noise induced by the core. This mode called the Pseudo-Idle mode

(1),(2) is

enabled by setting the ADIDL bit in ADCON register

(3). Thus, when conversion is launched (see

Section "Conversion Launching", page 201), the CPU core is stopped until the end of the con-

ADEN

ADSST

ADEOC

TSETUP

TCONV

CLK

TADCLK

ADCD4:0

ADCLK

ADC Clock

ADCclk

PERclk

2 ADCD

⋅

-------------------------

ADC Clock Symbol

ADC

CLOCK

PER

CLOCK

÷ 2

ADCS

Channel

0AIN1

1AIN0

AT83SND2CMP3B bảng dữ liệu(PDF) 200 Page - ATMEL Corporation

AT83SND2CMP3B bảng dữ liệu(HTML) 200 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL