| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
VD6640 bảng dữ liệu(PDF) 111 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
VD6640 bảng dữ liệu(HTML) 111 Page - STMicroelectronics |
|
111 / 126 page ![]() DocID023597 Rev 11 111/126 VG6640, VD6640 Application 125 11.5 I2C pull-up resistors If the I2C interface is to only be used in Fast mode (400KHz) then a pull-up resistor value of around 1K ohm is recommended for the SDA signal. If the I2C interface is to be used in Fast+ mode (1MHz) then the value of pull-up resistor must be chosen to ensure I2C bus constraints are met in both Fast and Fast+ mode. This is due to the fact the 6640 will initially be in Fast mode, with a low current sink capability on SDA, then will be switched to Fast+ mode via an I2C write. To ensure that the SDA signal can correctly ACK a transaction in Fast mode the pull-up resistance must not be too low. A value of around 600 ohms is appropriate to meet this constraint. Correct characteristics of the I2C signals should always be check by measurements on actual circuit boards as PCB parasitic capacitance can affect the signal rise and fall times. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |