P89LPC915FDH datasheet(36/72 Pages) PHILIPS

36 / 72 page

Philips Semiconductors

P89LPC915/916/917

8-bit microcontrollers with accelerated two-clock 80C51 core

Product data

Rev. 04 — 17 December 2004

36 of 72

9397 750 14397

The P89LPC916supports 14 interrupt sources: external interrupt 0, timers 0 and 1,

serial port Tx, serial port Rx, combined serial port Rx and Tx, brownout detect,

Watchdog/Real-Time clock, I2C, keyboard, comparators 1 and 2, SPI, and the A/D

converter.

Each interrupt source can be individually enabled or disabled by setting or clearing a

bit in the interrupt enable registers IEN0 or IEN1. The IEN0 register also contains a

global disable bit, EA, which disables all interrupts.

Each interrupt source can be individually programmed to one of four priority levels by

setting or clearing bits in the interrupt priority registers IP0, IP0H, IP1, and IP1H. An

interrupt service routine in progress can be interrupted by a higher priority interrupt,

but not by another interrupt of the same or lower priority. The highest priority interrupt

service cannot be interrupted by any other interrupt source. If two requests of

different priority levels are pending at the start of an instruction, the request of higher

priority level is serviced.

If requests of the same priority level are pending at the start of an instruction, an

internal polling sequence determines which request is serviced. This is called the

arbitration ranking. Note that the arbitration ranking is only used to resolve pending

requests of the same priority level.

9.11.1

External interrupt inputs

The P89LPC915 and P89LPC917 have two external interrupt inputs as well as the

Keypad Interrupt function. The P89LPC916 has one external interrupt input as well as

the Keypad Interrupt function These external interrupt inputs are identical to those

present on the standard 80C51 microcontrollers.

These external interrupts can be programmed to be level-triggered or edge-triggered

by setting or clearing bit IT1 or IT0 in Register TCON.

In edge-triggered mode, if successive samples of the INTn pin show a HIGH in one

cycle and a LOW in the next cycle, the interrupt request ﬂag IEn in TCON is set,

causing an interrupt request.

If an external interrupt is enabled when the P89LPC915/916/917 is put into

Power-down or Idle mode, the interrupt will cause the processor to wake-up and

resume operation. Refer to Section 9.14 “Power reduction modes” for details.

P89LPC915FDH bảng dữ liệu(PDF) 36 Page - NXP Semiconductors