DSOX4MASK datasheet(10/39 Pages) KEYSIGHT

10 / 39 page

10 | Keysight | InﬁniiVision 4000 X-Series Oscilloscopes - Data Sheet

Zone touch trigger

One of the biggest challenges of using an oscilloscope is setting

up an advanced trigger to isolate a signal of interest. While

advanced triggers are powerful features, zone touch trigger

provides a turnkey trigger solution.

You simply observe the signal of interest on the display, and

draw a zone (box) around it. What used to be hours of work can

now take just a few seconds. If you want to move your zones to

another location, just drag them over. The 4000 X-Series can be

set up to easily trigger on one or two zone boxes simultaneously

with either must intersect or must not intersect conditions.

Zone triggering does not compromise the waveform update

rate; the 4000 X-Series will still maintain an ultra-fast 200,000

waveforms per second or more, even with additional features

turned on. In other words, the oscilloscope that sees everything

can easily trigger on anything.

Zone touch trigger + segment memory: A whole

new experience

The combination of the industry’s only hardware-based zone

touch trigger with the 4000 X-Series’ segment memory simplifies

and enhances your debugging experience. In Figure 16, the 4000

X-Series has isolated and captured 1,000 metastable signals,

showing the critical bit errors over a 32-second time span at

5 GS/s sampling rate in the segment memory. The segment

memory also allows you to overlay all segments to identify the

worst-case signal.

Figure 15. When you see anomalies, all you have to do is

draw a zone box to trigger on them.

Figure 16. Combination of the zone touch trigger and

segmented memory.

Oscilloscope Experience Redefined:

Experience the Usability (Continued)

DSOX4MASK bảng dữ liệu(PDF) 10 Page - Keysight Technologies