LTC2413IGN datasheet(23/44 Pages) LINER

23 / 44 page

LTC2413

sn2413 2413fs

APPLICATIO S I FOR ATIO

CS is discharging; therefore, the internal serial clock

timing mode is automatically selected if SCK is floating. It

is important to ensure there are no external drivers pulling

SCK LOW while CS is discharging.

PRESERVING THE CONVERTER ACCURACY

The LTC2413 is designed to reduce as much as possible

the conversion result sensitivity to device decoupling,

PCB layout, antialiasing circuits, line frequency perturba-

tions and so on. Nevertheless, in order to preserve the

extreme accuracy capability of this part, some simple

precautions are desirable.

Digital Signal Levels

The LTC2413’s digital interface is easy to use. Its digital

inputs (FO, CS and SCK in External SCK mode of operation)

accept standard TTL/CMOS logic levels and the internal

hysteresis receivers can tolerate edge rates as slow as

100

µs.However,someconsiderationsarerequiredtotake

advantage of the exceptional accuracy and low supply

current of this converter.

The digital output signals (SDO and SCK in Internal SCK

mode of operation) are less of a concern because they are

not generally active during the conversion state.

While a digital input signal is in the range 0.5V to

(VCC – 0.5V), the CMOS input receiver draws additional

current from the power supply. It should be noted that,

when any one of the digital input signals (FO, CS and SCK

in External SCK mode of operation) is within this range, the

LTC2413 power supply current may increase even if the

signal in question is at a valid logic level. For micropower

operation, it is recommended to drive all digital input

signals to full CMOS levels [VIL < 0.4V and VIH >

(VCC – 0.4V)].

During the conversion period, the undershoot and/or

overshoot of a fast digital signal connected to the LTC2413

pins may severely disturb the analog to digital conversion

process. Undershoot and overshoot can occur because of

the impedance mismatch at the converter pin when the

transition time of an external control signal is less than

twice the propagation delay from the driver to LTC2413.

For reference, on a regular FR-4 board, signal propagation

Figure 13. CS Capacitance vs tSAMPLE

Figure 14. CS Capacitance vs Output Rate

Figure 15. CS Capacitance vs Supply Current

CAPACITANCE ON CS (pF)

1000

10000

2413 F13

100

100000

VCC = 5V

VCC = 3V

CAPACITANCE ON CS (pF)

1000

100000

2413 F14

100

10000

VCC = 5V

VCC = 3V

CAPACITANCE ON CS (pF)

100

150

200

250

300

100

1000

10000

2413 F15

100000

VCC = 5V

VCC = 3V

LTC2413IGN bảng dữ liệu(PDF) 23 Page - Linear Technology

LTC2413IGN bảng dữ liệu(HTML) 23 Page - Linear Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

bảng dữ liệu tải về

Link URL