2.2 mF

15

H

m

15 mH

OUTP

OUTN

L1

L2

C2

C3

2.2 mF

1 mF

1 mF

33

H

m

33 mH

OUTP

OUTN

L1

L2

C2

C3

1nF

Ferrite

ChipBead

OUTP

OUTN

Ferrite

ChipBead

1nF

19

TPA3136D2, TPA3136AD2

www.ti.com

SLOS938D – MAY 2016 – REVISED MARCH 2017

Product Folder Links: TPA3136D2 TPA3136AD2

Submit Documentation Feedback

Copyright © 2016–2017, Texas Instruments Incorporated

Typical Applications (continued)

10.2.2.3 When to Use an Output Filter for EMI Suppression

The TPA3136D2 device has been tested with a simple ferrite bead filter for a variety of applications including

long speaker wires up to 100 cm and high power. The TPA3136D2 EVM passes FCC Class B specifications

under these conditions using twisted speaker wires. The size and type of ferrite bead can be selected to meet

application requirements. Also, the filter capacitor can be increased if necessary with some impact on efficiency.

There may be a few circuit instances where it is necessary to add a complete LC reconstruction filter. These

circumstances might occur if there are nearby circuits which are sensitive to noise. In these cases a classic

second order Butterworth filter similar to those shown in the figures below can be used.

Some systems have little power supply decoupling from the AC line but are also subject to line conducted

interference (LCI) regulations. These include systems powered by "wall warts" and "power bricks." In these

cases, LC reconstruction filters can be the lowest cost means to pass LCI tests. Common mode chokes using

low frequency ferrite material can also be effective at preventing line conducted interference.

Figure 20. Typical Ferrite Chip Bead Filter (Chip Bead Example: NFZ2MSM series from Murata)

Figure 21. Typical LC Output Filter, Cutoff Frequency of 27 kHz, Speaker Impedance = 8

Ω

Figure 22. Typical LC Output Filter, Cutoff Frequency of 27 kHz, Speaker Impedance = 6

Ω

10.2.2.4 Input Resistance

The typical input resistance of the amplifier is fixed to 30 k

Ω ±20%.