STM32F358XC datasheet(58/134 Pages) STMICROELECTRONICS

58 / 134 page

Electrical characteristics

STM32F358xC

58/134

DocID025540 Rev 4

6.3.4

Supply current characteristics

The current consumption is a function of several parameters and factors such as the

operating voltage, ambient temperature, I/O pin loading, device software configuration,

operating frequencies, I/O pin switching rate, program location in memory and executed

binary code.

The current consumption is measured as described in Figure 11: Current consumption

measurement scheme.

All Run-mode current consumption measurements given in this section are performed with a

reduced code that gives a consumption equivalent to CoreMark code.

Typical and maximum current consumption

The MCU is placed under the following conditions:

•

All I/O pins are in input mode with a static value at VDD or VSS (no load)

•

All peripherals are disabled except when explicitly mentioned

•

The Flash memory access time is adjusted to the fHCLK frequency (0 wait state from 0

to 24 MHz,1 wait state from 24 to 48 MHz and 2 wait states from 48 to 72 MHz)

•

Prefetch in ON (reminder: this bit must be set before clock setting and bus prescaling)

•

When the peripherals are enabled fPCLK2 = fHCLK and fPCLK1 = fHCLK/2

•

When fHCLK > 8 MHz, the PLL is ON and the PLL input is equal to HSI/2 (4 MHz) or

HSE (8 MHz) in bypass mode.

The parameters given in Table 28 to Table 37 are derived from tests performed under

ambient temperature and supply voltage conditions summarized in Table 24.

STM32F358XC bảng dữ liệu(PDF) 58 Page - STMicroelectronics