ST72321R7-Auto datasheet(185/243 Pages) STMICROELECTRONICS

185 / 243 page

ST72321xx-Auto

Electrical characteristics

Doc ID 13829 Rev 1

185/243

Electrical characteristics

19.1

Parameter conditions

Unless otherwise specified, all voltages are referred to VSS.

19.1.1

Minimum and maximum values

Unless otherwise specified the minimum and maximum values are guaranteed in the worst

conditions of ambient temperature, supply voltage and frequencies by tests in production on

100% of the devices with an ambient temperature at TA = 25°C and TA =TAmax (given by the

selected temperature range).

Data based on characterization results, design simulation and/or technology characteristics

are indicated in the table footnotes and are not tested in production. Based on

characterization, the minimum and maximum values refer to sample tests and represent the

mean value plus or minus three times the standard deviation (mean ±3

).

19.1.2

Typical values

Unless otherwise specified, typical data is based on TA =25°C, VDD = 5V. The typical values

are given only as design guidelines and are not tested.

19.1.3

Typical curves

Unless otherwise specified, all typical curves are given only as design guidelines and are

not tested.

19.1.4

Loading capacitor

The loading conditions used for pin parameter measurement are shown in Figure 71.

Figure 71.

Pin loading conditions

19.1.5

Pin input voltage

The input voltage measurement on a pin of the device is described in Figure 72.

Figure 72.

Pin input voltage

ST7 PIN

VIN

ST7 PIN

ST72321R7-Auto bảng dữ liệu(PDF) 185 Page - STMicroelectronics