ST72321R7-Auto datasheet(126/243 Pages) STMICROELECTRONICS

tên linh kiện	ST72321R7-Auto

Giải thích chi tiết về linh kiện	PLL for 2x frequency multiplication

PDF	243 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

126 / 243 page

Serial peripheral interface (SPI)

ST72321xx-Auto

126/243

Doc ID 13829 Rev 1

The SPIF bit can be cleared during a second transmission; however, it must be cleared

before the second SPIF bit in order to prevent an Overrun condition (see Overrun condition

(OVR) on page 128).

14.4

Clock phase and clock polarity

Four possible timing relationships may be chosen by software, using the CPOL and CPHA

bits (see Figure 59).

Note:

The idle state of SCK must correspond to the polarity selected in the SPICSR register (by

pulling up SCK if CPOL = 1 or pulling down SCK if CPOL = 0).

The combination of the CPOL clock polarity and CPHA (clock phase) bits selects the data

capture clock edge

Figure 59 shows an SPI transfer with the four combinations of the CPHA and CPOL bits.

The diagram may be interpreted as a master or slave timing diagram where the SCK pin, the

MISO pin, the MOSI pin are directly connected between the master and the slave device.

Note:

If CPOL is changed at the communication byte boundaries, the SPI must be disabled by

resetting the SPE bit.

ST72321R7-Auto bảng dữ liệu(PDF) 126 Page - STMicroelectronics