ST72321R7-Auto datasheet(102/243 Pages) STMICROELECTRONICS

102 / 243 page

16-bit timer

ST72321xx-Auto

102/243

Doc ID 13829 Rev 1

13.3.2

External clock

The external clock (where available) is selected if CC0 = 1 and CC1 = 1 in the CR2 register.

The status of the EXEDG bit in the CR2 register determines the type of level transition on

the external clock pin EXTCLK that will trigger the free running counter.

The counter is synchronized with the falling edge of the internal CPU clock.

A minimum of four falling edges of the CPU clock must occur between two consecutive

active edges of the external clock; thus, the external clock frequency must be less than a

quarter of the CPU clock frequency.

Figure 43.

Counter timing diagram, internal clock divided by 2

Figure 44.

Counter timing diagram, internal clock divided by 4

Figure 45.

Counter timing diagram, internal clock divided by 8

Note:

The MCU is in reset state when the internal reset signal is high; when it is low the MCU is

running.

CPU CLOCK

FFFD FFFE FFFF 0000

0001

0002

0003

INTERNAL RESET

TIMER CLOCK

COUNTER REGISTER

TIMER OVERFLOW FLAG (TOF)

FFFC

FFFD

0000

0001

CPU CLOCK

INTERNAL RESET

TIMER CLOCK

COUNTER REGISTER

TIMER OVERFLOW FLAG (TOF)

CPU CLOCK

INTERNAL RESET

TIMER CLOCK

COUNTER REGISTER

TIMER OVERFLOW FLAG (TOF)

FFFC

FFFD

0000

ST72321R7-Auto bảng dữ liệu(PDF) 102 Page - STMicroelectronics

ST72321R7-Auto bảng dữ liệu(HTML) 102 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL