| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
UM1539 bảng dữ liệu(PDF) 13 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
UM1539 bảng dữ liệu(HTML) 13 Page - STMicroelectronics |
|
13 / 46 page ![]() UM1539 Getting started Doc ID 023106 Rev 1 13/46 Figure 6. Wrong address message on GUI 1.2.11 GUI window for STTS424E02 temperature sensor The STTS424E02 is a simple digital temperature sensor with an on-chip 2 Kb EEPROM. Below are the steps to operate the STTS424E02 sensor in GUI mode: 1. Plug the daughter card of the STTS424E02 on the motherboard. 2. Select the sensor option for the STTS424E02 from the GUI, as shown in Figure 4. 3. Select the STTS424E02 sensor Radio button from sensor options in the “Select the Temperature Sensor” area in the GUI. On selecting the STTS424E02 sensor, the “Edit EEPROM” option also gets enabled in the GUI. 4. Check the address from the “Choose Address” area. If the address configured on the board (explained in Section 1.2.6) is different from the address selected from the GUI, an error message appears on the GUI. In the case of an error, re-check the address with the correct option. 5. All the registers show the default readings at first selection. 6. Press the Loop button to continuously read the temperature in the GUI. 7. Configure the different registers through the GUI and observe the behavior of the sensor. The bits of the configuration register can be individually selected using the GUI. 8. Sliders for “Upper Temp Register”, “Lower Temp Register” and “Critical Temp Register” can be used to separately configure the upper boundary, lower boundary and critical limit for temperatures. Press the Write button individually for all the three limits to write the value inside the sensor registers. 9. The Once button is used to read the instantaneous value of temperature value from the sensor. 10. The Loop button is used to continuously read the temperature value from the sensor and display the same in the GUI. 11. There are 3 different alarms supported by this sensor: a) Below alarm window (BAW): This alarm occurs when the measured temperature goes below the temperature setting performed in the alarm temperature lower boundary register (lower temp |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |