QT20.361

Q-Series

Oct. 2006 / Rev. 1.0 DS-QT20.361-EN

All parameters are specified at 36V, 13.3A, 3x400Vac, 25°C ambient and after a 5 minutes run-in time unless otherwise noted.

www.pulspower.com Phone +49 89 9278 0

Germany

11/23

16. EMC

The power supply is suitable for applications in industrial environment as well as in residential, commercial and light

industry environment without any restrictions. CE mark is in conformance with EMC guideline 89/336/EEC and

93/68/EEC and the low-voltage directive (LVD) 73/23/EWG. A detailed EMC Report is available upon request

EMC Immunity

EN 61000-6-1 EN 61000-6-2

Generic standards

Electrostatic discharge

EN 61000-4-2

Contact discharge

Air discharge

8kV

15kV

Criterion A

Criterion A

Electromagnetic RF field

EN 61000-4-3

80MHz-1GHz

10V/m

Criterion A

Fast transients (Burst)

EN 61000-4-4

Input lines

Output lines

4kV

2kV

Criterion A

Criterion A

Surge voltage on input

EN 61000-4-5

L1

L2, L2

L3,

L1

L3

2kV

Criterion A

Surge voltage on input

EN 61000-4-5

L1 / L2 / L3

PE

4kV

Criterion A

Surge voltage on output

EN 61000-4-5

+

-

+ / -

PE

500V

500V

Criterion A

Criterion A

Conducted disturbance

EN 61000-4-6

0.15-80MHz

10V

Criterion A

Mains voltage dips

Dip on all three phases

EN 61000-4-11

70% of 380Vac

40% of 380Vac

40% of 380Vac

266Vac, 10ms

152Vac, 100ms

152Vac, 1000ms

Criterion A

Criterion C

Criterion C

Mains voltage dips

Dip on one phase

EN 61000-4-11

70% of 380Vac

40% of 380Vac

40% of 380Vac

266Vac, 10ms

152Vac, 100ms

152Vac, 1000ms

Criterion A

Criterion A

Criterion A

Voltage interruptions

EN 61000-4-11

0Vac, 5000ms

Criterion C

Voltage sags

SEMI F47 0200

Dips on two phases

according to section

7.2. (SEMI F47-200)

304Vac, 1000ms

266Vac, 500ms

190Vac, 200ms

Criterion A

Criterion A

Criterion A

Powerful transients

VDE 0160

over entire load

range

1300V, 1.3ms

Criterion A

Criterions:

A: Power supply shows normal operation behavior within the defined limits.

C: Temporary loss of function is possible. Power supply might shut-down and restarts by itself. No damages or hazards for the power supply occur.

EMC Emission

EN 61000-6-3 and EN 61000-6-4

Generic standards

Conducted emission

EN 55011, EN 55022, FCC Part 15, CISPR 11, CISPR 22

Class B, input lines

Radiated emission

EN 55011, EN 55022

Class B

Harmonic input current

EN 61000-3-2

Fulfilled, active PFC

Voltage fluctuations, flicker

EN 61000-3-3

Fulfilled

This device complies with FCC Part 15 rules.

Operation is subjected to following two conditions: (1) this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause undesired operation.

Switching Frequencies

The power supply has three converters with three different switching frequencies

included. Two are nearly constant. The other one is input voltage and load dependent.

Switching frequency 1

100kHz

Nearly constant

Switching frequency 2

30kHz to 90kHz

Input voltage and load dependent

Switching frequency 3

40kHz to 220kHz

Input voltage and load dependent