công cụ tìm kiếm bảng dữ liệu linh kiện điện tử
  Vietnamese  ▼
ALLDATASHEET.VN

X  

CY7C63413-PVC bảng dữ liệu(PDF) 16 Page - Cypress Semiconductor

tên linh kiện CY7C63413-PVC
Giải thích chi tiết về linh kiện  Low-speed USB Peripheral Controller
PDF  36 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
nhà sản xuất  CYPRESS [Cypress Semiconductor]
Trang chủ  http://www.cypress.com
Logo CYPRESS - Cypress Semiconductor

CY7C63413-PVC bảng dữ liệu(HTML) 16 Page - Cypress Semiconductor

Back Button CY7C63413-PVC Datasheet HTML 12Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 13Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 14Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 15Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 16Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 17Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 18Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 19Page - Cypress Semiconductor CY7C63413-PVC Datasheet HTML 20Page - Cypress Semiconductor Next Button
Zoom Inzoom in Zoom Outzoom out
 16 / 36 page
background image
CY7C63411/12/13
CY7C63511/12/13
CY7C63612/13
FOR
FOR
Document #: 38-08027 Rev. **
Page 16 of 36
8.2
Watch Dog Reset (WDR)
The Watch Dog Timer Reset (WDR) occurs when the Most Significant Bit (MSB) of the 2-bit Watch Dog Timer Register transitions
from LOW to HIGH. In addition to the normal reset initialization noted under “Reset,” bit 6 of the Processor Status and Control
Register is set to “1” to indicate to the firmware that a Watch Dog Reset occurred.
Figure 8-1. Watch Dog Reset (WDR)
The Watch Dog Timer is a 2-bit timer clocked by a 4.096-ms clock (bit 11) from the free-running timer. Writing any value to the
write-only Watch Dog Clear I/O port (0x26h) will clear the Watch Dog Timer.
In some applications, the Watch Dog Timer may be cleared in the 1.024-ms timer interrupt service routine. If the 1.024-ms timer
interrupt service routine does not get executed for 8.192 ms or more, a Watch Dog Timer Reset will occur. A Watch Dog Timer
Reset lasts for 2.048 ms after which the microcontroller begins execution at ROM address 0x0000h. The USB transmitter is
disabled by a Watch Dog Reset because the USB Device Address Register is cleared. Otherwise, the USB Controller would
respond to all address 0 transactions. The USB transmitter remains disabled until the MSB of the USB address register is set.
9.0
General Purpose I/O Ports
Ports 0 to 2 provide 24 GPIO pins that can be read or written. Each port (8 bits) can be configured as inputs with internal pull-
ups, open drain outputs, or traditional CMOS outputs. Please note an open drain output is also a high-impedance (no pull-up)
input. All of the I/O pins within a given port have the same configuration. Ports 0 to 2 are considered low current drive with typical
current sink capability of 7 mA.
The internal pull-up resistors are typically 7 k
Ω. Two factors govern the enabling and disabling of the internal pull-up resistors: the
port configuration selected in the GPIO Configuration register and the state of the output data bit. If the GPIO Configuration
selected is “Resistive” and the output data bit is “1,” then the internal pull-up resistor is enabled for that GPIO pin. Otherwise, Q1
is turned off and the 7-k
Ω pull-up is disabled. Q2 is “ON” to sink current whenever the output data bit is written as a “0.” Q3
Figure 9-1. Block Diagram of a GPIO Line
At least 8.192 ms
WDR goes high
Execution begins at
Reset Vector 0X00
8.192 ms
2.048 ms
since last write to WDT
for 2.048 ms
to 14.336 ms
GPIO
Pin
VCC
7 k
Ω
ESD
GPIO
CFG
mode
2 bits
Data
Out
Latch
Internal
Data Bus
Port Read
Port Write
Interrupt
Enable
to Interrupt
Controller
Q1
Q2
Q3
Internal
Buffer



Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36


bảng dữ liệu tải về

Go To PDF Page


Link URL



Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không?  [ DONATE ] 

Alldatasheet là   |   Quảng cáo   |   Liên lạc với chúng tôi   |   Chính sách bảo mật   |   Liên kết đến bảng dữ liệu    |   Trao đổi link   |   Tìm kiếm theo nhà sản xuất
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com