DP8390D datasheet(33/56 Pages) NSC

33 / 56 page

130 Bus Arbitration and Timing

The NIC operates in three possible modes

TLF8582 – 64

Upon power-up the NIC is in an indeterminant state After

receiving a Hardware Reset the NIC comes up as a slave in

the Reset State The receiver and transmitter are both dis-

abled in this state The reset state can be reentered under

three conditions soft reset (Stop Command) hard reset

(RESET input) or an error that shuts down the receiver or

transmitter (FIFO underflow or overflow) After initialization

of registers the NIC is issued a Start command and the NIC

enters Idle state Until the DMA is required the NIC remains

in an idle state The idle state is exited by a request from the

FIFO in the case of receive or transmit or from the Remote

DMA in the case of Remote DMA operation After acquiring

the bus in a BREQBACK handshake the Remote or Local

DMA transfer is completed and the NIC reenters the idle

state

DMA TRANSFERS TIMING

The DMA can be programmed for the following types of

transfers

16-Bit Address 8-bit Data Transfer

16-Bit Address 16-bit Data Transfer

32-Bit Address 8-bit Data Transfer

32-Bit Address 16-bit Data Transfer

All DMA transfers use BSCK for timing 16-Bit Address

modes require 4 BSCK cycles as shown below

16-Bit Address 8-Bit Data

TLF8582 – 65

DP8390D bảng dữ liệu(PDF) 33 Page - National Semiconductor (TI)