| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
DP83266 bảng dữ liệu(PDF) 71 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
DP83266 bảng dữ liệu(HTML) 71 Page - National Semiconductor (TI) |
|
71 / 152 page ![]() 70 Control Information (Continued) Exception Status Register (ESR) The Exception Status Register (ESR) reports errors to the software Errors include PHY Interface Parity Errors illegal attempts to access currently inaccessible registers and writing to a conditional write location if a register bit has changed since it was last read Each bit may be masked via the Exception Mask Register (EMR) Access Rules Address Read Write 02Ch Always Conditional Register Bits D7 D6 D5 D4 D3 D2 D1 D0 CWI CCE CPE RES RES RES RES PPE Bit Symbol Description D7 CWI Conditional Write Inhibit Indicates that at least one bit of the previous conditional write operation was not written This bit is set unconditionally after each write to a conditional write register if the value of the Compare Register is not equal to the value of the register that was accessed for a write before it was written This may indicate that the accessed register has changed since it was last read This bit is cleared after a successful conditional write This occurs when the value of the Compare Register is equal to the value of the register that was accessed for a write before it was written CWI does not contribute to setting the ESE bit of the Interrupt Condition Register (it is always implicitly masked) D6 CCE Control Bus Command Error Indicates that a Control Bus command was not performed due to an error ie illegal command or a Control Bus Write Parity Error An illegal command is an attempt to access a currently inaccessible register D5 CPE Control Bus Parity Error Indicates a Control Bus Parity Error was detected on the Control Bus Data pins (CBD7 – 0) during a write operation to a register Parity errors are reported if parity is enabled on the Control Bus Interface (bit CBP of the Mode Register is set) D4 – D1 RES Reserved D0 PPE PHY Interface Parity Error Indicates parity error detected on PID7 – 0 Parity errors are reported when parity is enabled on the PHY Request Interface (bit PIP of the Mode Register is set) 71 |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |