B7

B

Frame Kit Assembly Process

Assembly Process Figure 1

Mount the connectors(68-contact connectors,

back connectors) and other parts to the

printed circuit board (PCB).

NOTE :The procedure for the IC9 Series (suited to the

68-contact connectors and card bus) is to mount

the connector body, then insert the ground plate

and fasten the lead portion by hand.

Assembly Process Figure 2

Insert the PCB mounting part to panel B

(frame press fitting item).

Assembly Process Figure 3

Use the assembly jig (described below) to

insert panel A. (Press fit + lock)

Assembly Process Figure 4

Assembled item

Assembly Process Figure 5

Affix the label to the indented portion of the panel.

NOTE :Hirose Electric Co. Ltd. will not provide label services.

(Please refer to the Recommended Label Dimensions

Diagram of Page 2.)

Assembly Jig

(The photograph shows the hand press model.)

Panel B

Panel A

Part Number

NX1-/CVCK-MP

NX1-/CVCK-MP(01)

CL No.

902-3530-7

902-3530-7(01)

Classification

Without hand press

With hand press

PCB

68-Contact connector

Back connector