CAP1298 datasheet(47/68 Pages) MICROCHIP

47 / 68 page

 2013-2015 Microchip Technology Inc.

DS00001571B-page 47

CAP1298

Bit 7 - AVG_SUM - Determines whether the sensor inputs enabled in Standby will average the programmed number of

samples or whether they will accumulate for the programmed number of samples.

• ‘0’ - (default) - The Standby enabled sensor input delta count values will be based on the average of the pro-

grammed number of samples when compared against the threshold.

• ‘1’ - The Standby enabled sensor input delta count values will be based on the summation of the programmed

number of samples when compared against the threshold. Caution should be used with this setting as a touch

may overflow the delta count registers and may result in false readings.

Bits 6 - 4 - STBY_AVG[2:0] - Determines the number of samples that are taken for all Standby enabled channels during

the sensing cycle as shown in Table 5-6. All samples are taken consecutively on the same channel before the next chan-

nel is sampled and the result is averaged over the number of samples measured before updating the measured results.

Bit 3 - 2 - STBY_SAMP_TIME[1:0] - Determines the time to take a single sample for sensor inputs enabled in Standby

as shown in Table 5-7.

Bits 1 - 0 - STBY_CY_TIME[2:0] - Determines the desired sensing cycle time for sensor inputs enabled during Standby,

as shown in Table 5-8. This control is also used to determine programmed cycle time in the Combo state (see Section

4.3.1.3, "Combo State Sensing Settings"). All enabled channels are sampled at the beginning of the sensing cycle. If

additional time is remaining, the device is placed into a lower power state for the remainder of the sensing cycle.

TABLE 5-6:

STBY_AVG BIT DECODE

STBY_AVG[2:0]

Number Of Samples Taken Per

Measurement

8 (default)

128

TABLE 5-7:

STBY_SAMP_TIME BIT DECODE

STBY_SAMP_TIME[1:0]

Sampling Time

320us

640us

1.28ms (default)

2.56ms

CAP1298 bảng dữ liệu(PDF) 47 Page - Microchip Technology