80960KA

15

2.7.

DC Characteristics

2.6.

Absolute Maximum Ratings

NOTICE: This is a production data sheet. The specifi-

cations are subject to change without notice.

Operating Temperature

(PGA).............. 0°C to +85°C Case

(PQFP) ......... 0°C to +100°C Case

Storage Temperature ................................. –65°C to +150°C

Power Dissipation .......................................... 2.5W (25 MHz)

*WARNING: Stressing the device beyond the “Absolute Maxi-

mum Ratings” may cause permanent damage. These are

stress ratings only. Operation beyond the “Operating Condi-

tions” is not recommended and extended exposure beyond the

“Operating Conditions” may affect device reliability.

PGA:

PQFP:

Table 5. DC Characteristics

Symbol

Parameter

Min

Max

Units

Notes

Input Low Voltage

–0.3

+0.8

V

Input High Voltage

2.0

V

CLK2 Input Low Voltage

–0.3

+0.8

V

CLK2 Input High Voltage

V

Output Low Voltage

0.45

V

(1,2)

Output High Voltage

2.4

V

(3,4)

Power Supply Current:

16 MHz

20 MHz

25 MHz

315

360

420

mA

mA

mA

(5)

(5)

(5)

Input Leakage Current

±15

µA

0

≤ V

Output Leakage Current

±15

µA

0.45

≤ V

Input Capacitance

10

pF

Output Capacitance

12

pF

Clock Capacitance

10

pF

NOTES:

1. For three-state outputs, this parameter is measured at:

Address/Data ............................................................................................................................................................................................. 4.0 mA

Controls ...................................................................................................................................................................................................... 5.0 mA

2. For open-drain outputs ................................................................................................................................................................................ 25 mA

3. This parameter is measured at:

Address/Data ........................................................................................................................................................................................... -1.0 mA

Controls .................................................................................................................................................................................................... -0.9 mA

ALE .......................................................................................................................................................................................................... -5.0 mA

4. Not measured on open-drain outputs.

Figure 7, Figure 8 and Figure 9 indicate typical values.

6. Input, output and clock capacitance are not tested.