L1C datasheet(23/42 Pages) RENESAS

23 / 42 page

QB-RL78L1C In-Circuit Emulator

CHAPTER 2

SETUP PROCEDURE

R20UT2703EJ0200

Rev.2.00

Page 23 of 42

Jan 31, 2014

2.3

Mounting and Connecting Connectors

This section describes the methods of connecting the QB-RL78L1C and target system.

Make connections with both the QB-RL78L1C and target system powered OFF.

The following abbreviations are used in this section:

- NQ: Target connector

- YQ: YQ connector

- EA: Exchange adapter

- MA: Mount adapter

- CA: Check pin adapter

- SA: Space adapter

2.3.1

Mounting NQ to target system

(1) Thinly apply a two-component epoxy adhesive (hardening time at least 30 minutes) to the ends of the four

projections on the base of the NQ and adhere the NQ to the user board (clean the surface of the target system

board using alcohol or the like).

If alignment of target system pads to NQ leads is difficult, align them as in (2).

(2) Align by inserting the guide pins for alignment for the NQ (NQGUIDE) through the pin holes on the top of the

NQ. Accessory holes are

φ1.0 mm non-through holes in two or three places.

(For hole positions, see the particular NQ drawing.)

(3) Solder after fitting the MA to the NQ.

This is to prevent troubles such as flux or solder splashing and adhering

to the NQ contact pins when soldering.

- Soldering conditions

Solder reflow

260°C

× 10 seconds or less

Manual soldering

350°C

× 5 seconds or less (1 pin)

Caution

Do not perform washing by flux immersion or vapor.

(4) Take away the guide pins.

L1C bảng dữ liệu(PDF) 23 Page - Renesas Technology Corp