33461 datasheet(46/60 Pages) MACOM

46 / 60 page

SOLISTRAND, Budget and DIAMOND GRIP

Uninsulated Terminals and Splices

Catalog 65505

Revised 9-00

For drawings, technical data or samples, contact your AMP sales engineer or call the AMP Technical Support Center 1-800-522-6752.

Dimensions are in inches and millimeters unless otherwise specified. Values in brackets are metric equivalents.

Specifications subject to change. Consult AMP for latest specifications.

Description of MIL-T-7928G Test Procedures and Requirements for Terminals

Test

Group

Sequence

Type

Description

Samples subjected to 50 cycles, each cyle consisting of

Current Cycling

30 minutes at 125% of the current listed on page 48

followed by 15 minutes with no load.

Voltage Drop

See test method and requirements on page 48.

Vibration

See test method on page 46.

Voltage Drop

See test method and requirements on page 48.

Tensile

See test method and requirements on page 47.

Samples subjected to a salt spray/fog for 48 hours.

Salt Spray/Corrosion

Salt concentration to be 5%, temperature to be 35° C

(95°) F, relative humidity to be 95-98%.

Voltage Drop

See test method and requirements on page 48.

Tensile

See test method and requirements on page 47.

Heat Age

Samples subjected to 193° C for 120 hours then cooled

to 23° C within one hour.

Samples subjected to a salt spray/fog for 48 hours.

Salt Spray/Corrosion

Salt concentration to be 5%, temperature to be 35° C

(95°) F, relative humidity to be 95-98%.

Voltage Drop

See test method and requirements on page 48.

Tensile

See test method and requirements on page 47.

Wire Size

“D” Dimension

Duration of Test

#12 AWG and larger or terminals

12 inches

18 hours each on horizontal

with insulation support

and vertical axis.

#14 AWG and smaller with

17 inches

2 hours each on horizontal

no insulation support

and vertical axis.

Vibration to be a simple harmonic motion with an amplitude of 0.03 inches (0.06 total excursion). Frequency to vary

uniformly from 10–55 Hz and back to 10 Hz. Frequency to be traversed in approximately one minute.

Procedure for Vibration Testing of Terminals per MIL-T-7928G

33461 bảng dữ liệu(PDF) 46 Page - Tyco Electronics

33461 bảng dữ liệu(HTML) 46 Page - Tyco Electronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

bảng dữ liệu tải về

Link URL