L6480 datasheet(40/73 Pages) STMICROELECTRONICS

tên linh kiện	L6480

Giải thích chi tiết về linh kiện	The L6480, realized in analog mixed signal technology, is an advanced fully integrated solution suitable for driving two-phase bipolar stepper motors with microstepping.

PDF	73 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

40 / 73 page

Serial interface

L6480

40/73

Doc ID 023278 Rev 3

Serial interface

The integrated 8-bit serial peripheral interface (SPI) is used for a synchronous serial

communication between the host microprocessor (always master) and the L6480 (always

slave).

The SPI uses chip select (CS), serial clock (CK), serial data input (SDI) and serial data

output (SDO) pins. When CS is high the device is unselected and the SDO line is inactive

(high impedance).

The communication starts when CS is forced low. The CK line is used for synchronization of

data communication.

All commands and data bytes are shifted into the device through the SDI input, most

significant bit first. The SDI is sampled on the rising edges of the CK.

All output data bytes are shifted out of the device through the SDO output, most significant

bit first. The SDO is latched on the falling edges of the CK. When a return value from the

device is not available, an all zero byte is sent.

After each byte transmission the CS input must be raised and be kept high for at least tdisCS

in order to allow the device to decode the received command and put the return value into

the shift register.

All timing requirements are shown in Figure 19 (see Section 3 for values).

Multiple devices can be connected in daisy chain configuration, as shown in Figure 20.

Figure 19.

SPI timings diagram

L6480 bảng dữ liệu(PDF) 40 Page - STMicroelectronics