L6480 datasheet(33/73 Pages) STMICROELECTRONICS

tên linh kiện	L6480

Giải thích chi tiết về linh kiện	The L6480, realized in analog mixed signal technology, is an advanced fully integrated solution suitable for driving two-phase bipolar stepper motors with microstepping.

PDF	73 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

33 / 73 page

L6480

Functional description

Doc ID 023278 Rev 3

33/73

The ADC_OUT value can be used for motor supply voltage compensation or can be at the

user’s disposal.

6.18

Supply management and internal voltage regulators

The L6480 integrates two linear voltage regulators: the first one can be used to obtain gate

driver supply starting from a higher voltage (e.g. the motor supply one). Its output voltage

can be set to 7.5 V or 15 V according to the VCCVAL bit value (CONFIG register). The

second linear voltage regulator can be used to obtain the 3.3 V logic supply voltage.

The regolator is designed to supply the internal circuitry of the IC and should not be used to

supply external components.

The input and output voltages of both regulators are connected to external pins and the

regulators are totally independent: in this way a very flexible supply management can be

performed using external components or external supply voltages (Figure 15).

Figure 15.

Device supply pin management

If VCC is externally supplied, the VSREG and VCC pins must be shorted (VSREG must be

compliant with VCC range).

If VREG is externally supplied, the VCCREG and VREG pins must be shorted and equal to

3.3 V.

VSREG must be always less than VBOOT in order to avoid related ESD protection diode turn-

on. The device can be protected from this event by adding an external low drop diode

between the VSREG and VS pins, charge pump diodes should be low drop too.

VCCREG must be always less than VCC in order to avoid ESD protection diode turn-on. The

device can be protected from this event by adding an external low drop diode between the

VCCREG and VSREG pins.

Both regulators provide a short circuit protection limiting the load current within the

respective maximum ratings.

L6480 bảng dữ liệu(PDF) 33 Page - STMicroelectronics