WM8983GEFLSLASHV datasheet(13/124 Pages) WOLFSON

13 / 124 page

Production Data

WM8983

PD, Rev 4.3, May 2010

Test Conditions

DCVDD=1.8V, AVDD1=AVDD2=DBVDD=3.3V, TA = +25

oC, 1kHz signal, fs = 48kHz, 24-bit audio data unless otherwise stated.

PARAMETER

SYMBOL

TEST CONDITIONS

MIN

TYP

MAX

UNIT

Digital Input / Output

Input HIGH Level

VIH

0.7

×DBV

Input LOW Level

VIL

0.3

×DBVDD

Output HIGH Level

VOH

IOL=1mA

0.9

×DBV

Output LOW Level

VOL

IOH=1mA

0.1xDBVDD

Input Capacitance

All digital pins

TERMINOLOGY

Full-scale input and output levels scale in relation to AVDD or AVDD2 depending upon the input or output used. For

example, when AVDD = 3.3V, 0dBFS = 1Vrms (0dBV). When AVDD < 3.3V the absolute level of 0dBFS will decrease

with a linear relationship to AVDD.

Input level to RIP and LIP in differential configurations is limited to a maximum of -3dB or performance will be reduced.

Signal-to-noise ratio (dBFS) – SNR is the difference in level between a reference full scale output signal and the

device output with no signal applied. This ratio is also called idle channel noise. (No Auto-zero or Automute function is

employed in achieving these results).

Total Harmonic Distortion (dBFS) – THD is the difference in level between a reference full scale output signal and the

first seven odd harmonics of the output signal. To calculate the ratio, the fundamental frequency of the output signal is

notched out and an RMS value of the next seven harmonics is calculated.

Total Harmonic Distortion plus Noise (dBFS) – THD+N is the difference in level between a reference full scale output

signal and the sum of the harmonics, wide-band noise and interference on the output signal. To calculate the ratio, the

fundamental frequency of the output signal is notched out and an RMS value of the total harmonics, wide-band noise

and interference is calculated.

Channel Separation (dB) – Also known as Cross-Talk. This is a measure of the amount one channel is isolated from

the other. Normally measured by sending a full scale signal down one channel and measuring the other.

The maximum output voltage can be limited by the speaker power supply. If SPKBOOST is set then AVDD2 should be

1.5xAVDD to prevent clipping taking place in the output stage (when PGA gains are set to 0dB).

WM8983GEFL/V bảng dữ liệu(PDF) 13 Page - Wolfson Microelectronics plc

WM8983GEFL/V bảng dữ liệu(HTML) 13 Page - Wolfson Microelectronics plc

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL