WM8980CGEFLSLASHV datasheet(38/123 Pages) WOLFSON

tên linh kiện	WM8980CGEFL/V

Giải thích chi tiết về linh kiện	Stereo CODEC with Speaker Driver and Video Buffer

PDF	123 Pages

Scroll/Zoom	100%

nhà sản xuất	WOLFSON [Wolfson Microelectronics plc]

Trang chủ	http://www.wolfsonmicro.com

Logo

38 / 123 page

WM8980

Pre-Production

PP, Rev 3.8, May 2012

LIMITER MODE

In limiter mode, the ALC will reduce peaks that go above the threshold level, but will not increase the

PGA gain beyond the starting level. The starting level is the PGA gain setting when the ALC is

enabled in limiter mode. If the ALC is started in limiter mode, this is the gain setting of the PGA at

start-up. If the ALC is switched into limiter mode after running in ALC mode, the starting gain will be

the gain at switchover. The diagram below shows an example of limiter mode.

Figure 18 ALC Limiter Mode Operation

ALC LIMITER MODE INITIALISATION SEQUENCE

In order to properly initialise the ALC function, the following sequence of register writes is required:

Set INPPGAVOLL to the required input PGA gain (R45[5:0]).

Enable analogue inputs (R44[2:0]) as required.

Disable INPPGAENL (R2[2] =0).

Set ALCMAXGAIN (R32[5:3]) and ALCMINGAIN (R32[2:0]) to the required level for operation.

Set ALCLVL (R33[3:0]) to the required level for operation.

Set R34 to 0x000.

Wait for 1ms to allow the input PGA gain to update by the limiter circuit.

Enable Limiter mode (R34[8]=1).

Wait for 1ms to allow the input PGA gain to update by the limiter circuit.

10. Enable INPPGAENL (R2[2] =1).

WM8980CGEFL/V bảng dữ liệu(PDF) 38 Page - Wolfson Microelectronics plc