L6472 datasheet(27/69 Pages) STMICROELECTRONICS

27 / 69 page

L6472

Functional description

Doc ID 022729 Rev 1

27/69

6.8

Internal oscillator and oscillator driver

The control logic clock can be supplied by the internal 16-MHz oscillator, an external

oscillator (crystal or ceramic resonator) or a direct clock signal.

These working modes can be selected by the EXT_CLK and OSC_SEL parameters in the

CONFIG register (see Table 24).

At power-up the device starts using the internal oscillator and provides a 2-MHz clock signal

on the OSCOUT pin.

Attention:

In any case, before changing clock source configuration, a

hardware reset is mandatory. Switching to different clock

configurations during operation could cause unexpected

behavior.

6.8.1

Internal oscillator

In this mode the internal oscillator is activated and OSCIN is unused. If the OSCOUT clock

source is enabled, the OSCOUT pin provides a 2, 4, 8 or 16-MHz clock signal (according to

the OSC_SEL value); otherwise it is unused (see Figure 12).

6.8.2

External clock source

Two types of external clock source can be selected: crystal/ceramic resonator or direct clock

source. Four programmable clock frequencies are available for each external clock source:

8, 16, 24 and 32 MHz.

When an external crystal/resonator is selected, the OSCIN and OSCOUT pins are used to

drive the crystal/resonator (see Figure 12). The crystal/resonator and load capacitors (CL)

must be placed as close as possible to the pins. Refer to Table 8 for the choice of the load

capacitor value according to the external oscillator frequency.

If a direct clock source is used, it must be connected to the OSCIN pin, and the OSCOUT

pin supplies the inverted OSCIN signal (see Figure 12).

Table 8.

CL values according to external oscillator frequency

Crystal/resonator freq. (1)

First harmonic resonance frequency.

CL (2)

Lower ESR value allows the driving of greater load capacitors.

8 MHz

25 pF (ESRmax = 80 Ω)

16 MHz

18 pF (ESRmax = 50 Ω)

24 MHz

15 pF (ESRmax = 40 Ω)

32 MHz

10 pF (ESRmax = 40 Ω)

L6472 bảng dữ liệu(PDF) 27 Page - STMicroelectronics

L6472 bảng dữ liệu(HTML) 27 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69

bảng dữ liệu tải về

Link URL