ATmega128 datasheet(295/386 Pages) ATMEL

tên linh kiện	ATmega128

Giải thích chi tiết về linh kiện	8-bit Microcontroller with 128K Bytes In-System Programmable Flash

PDF	386 Pages

Scroll/Zoom	100%

nhà sản xuất	ATMEL [ATMEL Corporation]

Trang chủ	http://www.atmel.com

Logo

295 / 386 page

295

2467S–AVR–07/09

ATmega128

Figure 137. Programming the Flash Waveforms

Note:

“XX” is don’t care. The letters refer to the programming description above.

Programming the

EEPROM

The EEPROM is organized in pages, see Table 124 on page 292. When programming the

EEPROM, the program data is latched into a page buffer. This allows one page of data to be

programmed simultaneously. The programming algorithm for the EEPROM data memory is as

follows (refer to “Programming the Flash” on page 293 for details on Command, Address and

Data loading):

A: Load Command “0001 0001”.

G: Load Address High Byte ($00 - $FF).

B: Load Address Low Byte ($00 - $FF).

C: Load Data ($00 - $FF).

E: Latch data (give PAGEL a positive pulse).

K: Repeat 3 through 5 until the entire buffer is filled.

L: Program EEPROM page:

Set BS1 to “0”.

Give WR a negative pulse. This starts programming of the EEPROM page. RDY/BSY

goes low.

Wait until to RDY/BSY goes high before programming the next page.

(See Figure 138 for signal waveforms.)

RDY/BSY

RESET +12V

PAGEL

BS2

0x10

ADDR. LOW

ADDR. HIGH

DATA

DATA LOW

DATA HIGH

ADDR. LOW DATA LOW

DATA HIGH

XA1

XA0

BS1

XTAL1

ATmega128 bảng dữ liệu(PDF) 295 Page - ATMEL Corporation

ATmega128 bảng dữ liệu(HTML) 295 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL