| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
EN56Q64-104FIP bảng dữ liệu(PDF) 1 Page - Eon Silicon Solution Inc. |
|
|
|||||||||||||||||||||||||||||
EN56Q64-104FIP bảng dữ liệu(HTML) 1 Page - Eon Silicon Solution Inc. |
|
1 / 60 page ![]() This Data Sheet may be revised by subsequent versions ©2004 Eon Silicon Solution, Inc., www.eonssi.com or modifications due to changes in technical specifications. 1 EN25Q64 Rev. E, Issue Date: 2009/10/19 FEATURES • Single power supply operation - Full voltage range: 2.7-3.6 volt • Serial Interface Architecture - SPI Compatible: Mode 0 and Mode 3 • 64 M-bit Serial Flash - 64 M-bit/8192 K-byte/32768 pages - 256 bytes per programmable page • Standard, Dual or Quad SPI - Standard SPI: CLK, CS#, DI, DO, WP# - Dual SPI: CLK, CS#, DQ0, DQ1, WP# - Quad SPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3 • High performance - 104MHz clock rate for one data bit - 50MHz clock rate for two data bits - 50MHz clock rate for four data bits • Low power consumption - 12 mA typical active current - 1 μA typical power down current • Uniform Sector Architecture: - 2048 sectors of 4-Kbyte - 128 blocks of 64-Kbyte - Any sector or block can be erased individually • Software and Hardware Write Protection: - Write Protect all or portion of memory via software - Enable/Disable protection with WP# pin • High performance program/erase speed - Page program time: 1.3ms typical - Sector erase time: 90ms typical - Block erase time 500ms typical - Chip erase time: 30 seconds typical • Write Suspend and Write Resume • Lockable 512 byte OTP security sector • Minimum 100K endurance cycle • Package Options - 8 pins SOP 200mil body width - 8 contact VDFN (5x6mm) - 8 contact VDFN (6x8mm) - 16 pins SOP 300mil body width - All Pb-free packages are RoHS compliant • Industrial temperature Range GENERAL DESCRIPTION The EN25Q64 is a 64 Megabit (8192K-byte) Serial Flash memory, with advanced write protection mechanisms. The EN25Q64 supports the standard Serial Peripheral Interface (SPI), and a high performance Dual output as well as Quad I/O using SPI pins: Serial Clock, Chip Select, Serial DQ0(DI), DQ1(DO), DQ2(WP#) and DQ3(NC). SPI clock frequencies of up to 50MHz are supported allowing equivalent clock rates of 100MHz for Dual Output and 200MHz for Quad Output when using the Dual/Quad Output Fast Read instructions. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction. The EN25Q64 is designed to allow either single Sector/Block at a time or full chip erase operation. The EN25Q64 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector or block. EN25Q64 64 Megabit Serial Flash Memory with 4Kbyte Uniform Sector |
Số phần tương tự - EN56Q64-104FIP |
|
Mô tả tương tự - EN56Q64-104FIP |
|
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |