LPC2917SLASH01 datasheet(56/86 Pages) NXP

56 / 86 page

LPC2917_19_01_2

Preliminary data sheet

Rev. 02 — 17 June 2009

56 of 86

NXP Semiconductors

LPC2917/01; LPC2919/01

ARM9 microcontroller with CAN and LIN

6.16 Vectored Interrupt Controller (VIC)

The LPC2917/2919/01 contains a very ﬂexible and powerful Vectored Interrupt Controller

to interrupt the ARM processor on request.

The key features are:

• Level-active interrupt request with programmable polarity.

• 56 interrupt-request inputs.

• Software-interrupt request capability associated with each request input.

• Interrupt request state can be observed before masking.

• Software-programmable priority assignments to interrupt requests up to 15 levels.

• Software-programmable routing of interrupt requests towards the ARM-processor

inputs IRQ and FIQ.

• Fast identiﬁcation of interrupt requests through vector.

• Support for nesting of interrupt service routines.

6.16.1 Functional description

The Vectored Interrupt Controller routes incoming interrupt requests to the ARM

processor. The interrupt target is conﬁgured for each interrupt request input of the VIC.

The targets are deﬁned as follows:

• Target 0 is ARM processor FIQ (fast interrupt service).

• Target 1 is ARM processor IRQ (standard interrupt service).

Interrupt-request masking is performed individually per interrupt target by comparing the

priority level assigned to a speciﬁc interrupt request with a target-speciﬁc priority

threshold. The priority levels are deﬁned as follows:

• Priority level 0 corresponds to ‘masked’ (i.e. interrupt requests with priority 0 never

lead to an interrupt).

• Priority 1 corresponds to the lowest priority.

CLK_SPI2

BASE_SPI_CLK

CLK_TMR0

BASE_TMR_CLK

CLK_TMR1

BASE_TMR_CLK

CLK_TMR2

BASE_TMR_CLK

CLK_TMR3

BASE_TMR_CLK

CLK_ADC1

BASE_ADC_CLK

CLK_ADC2

BASE_ADC_CLK

Table 31.

Branch clock overview …continued

Legend:

‘1’ Indicates that the related register bit is tied off to logic HIGH, all writes are ignored

‘0’ Indicates that the related register bit is tied off to logic LOW, all writes are ignored

‘+’ Indicates that the related register bit is readable and writable

Branch clock name

Base clock

Implemented switch on/off

mechanism

WAKE-UP

AUTO

RUN

LPC2917/01 bảng dữ liệu(PDF) 56 Page - NXP Semiconductors

LPC2917/01 bảng dữ liệu(HTML) 56 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86

bảng dữ liệu tải về

Link URL