AT91SAM9261 datasheet(12/43 Pages) ATMEL

12 / 43 page

6062KS–ATARM–15-Jan-09

AT91SAM9261 Preliminary

6.2

Test Pin

The TST pin is used for manufacturing test purposes when asserted high. It integrates a perma-

nent pull-down resistor of about 15 k

Ω to GNDBU, so that it can be left unconnected for normal

operations. Driving this line at a high level leads to unpredictable results.

6.3

Reset Pin

NRST is an open-drain output integrating a non-programmable pull-up resistor. It can be driven

with voltage at up to VDDIOP. As the product integrates power-on reset cells, the NRST pin can

be left unconnected in case no reset from the system needs to be applied to the product.

The NRST pin integrates a permanent pull-up resistor of 100 k

Ω minimum to VDDIOP.

The NRST signal is inserted in the Boundary Scan.

6.4

PIO Controller A, B and C Lines

All the I/O lines PA0 to PA31, PB0 to PB31, and PC0 to PC31 integrate a programmable pull-up

resistor of 100 k

Ω. Programming of this pull-up resistor is performed independently for each I/O

line through the PIO Controllers.

After reset, all the I/O lines default as inputs with pull-up resistors enabled, except those which

are multiplexed with the External Bus Interface signals that require to be enabled as Peripherals

at reset. This is explicitly indicated in the column “Reset State” of the PIO Controller multiplexing

tables.

6.5

Shutdown Logic Pins

The SHDN pin is an output only, driven by Shutdown Controller.

The pin WKUP is an input only. It can accept voltages only between 0V and VDDBU.

AT91SAM9261 bảng dữ liệu(PDF) 12 Page - ATMEL Corporation