ADE3800 datasheet(43/138 Pages) STMICROELECTRONICS

43 / 138 page

43/138

ADE3800

4.8

Sync Multiplexer (SMUX)

The SMUX block provides the ability to:

● Clamp (ADC Black level capture) pulse generation.

● Generate Data Enable from incoming HSync/Vsync signals.

● Select which sync source is used as internal reference.

Vertical enable (venab) and clamp are always generated.

SMEAS_STATUS_RANGE

0152

[7]

The meas_sticky_status bit is an OR of the STATUS_MASK

bits ANDed with their corresponding non-sticky range status

flags. This bit is sticky and can only be cleared by a write to

SMEAS_CLEAR[1]. The sticky bit goes to the scaler as a

signal to blank the output screen.

[6]

Indicates that the hpol measurement does not currently equal

the reference value. Not sticky.

[5]

Indicates that the vpol measurement does not currently equal

the reference value. Not sticky.

[4]

Indicates that the fastmute measurement is currently

exceeding the ref+tol. Not sticky.

[3]

Indicates that the xclks per vhi measurement is currently

exceeding the ref+tol. Not sticky.

[2]

Indicates that the horizontal per vertical measurement is

currently exceeding the ref+tol. Not sticky.

[1]

Indicates that the xclks per horizontal measurement is

currently exceeding the ref+tol. Not sticky.

[0]

Indicates that the xclks per vertical measurement is currently

exceeding the ref+tol. Not sticky.

SMEAS_MEAS_POLLING

0153

[1]

Horizontal measurement polling bit.

Toggles upon completion of each measurement in free-run

mode while SMEAS_H_CTRL[1] = 1. Undefined in one-shot

mode.

[0]

Vertical measurement polling bit.

Toggles upon completion of each measurement in free-run

mode while SMEAS_V_CTRL[1] = 1. Undefined in one-shot

mode.

SMEAS_STATUS_RANGE2

0155

[1]

indicates the current state of the line buffer pointer crossing

error check in the scaler.

[0]

indicates the current state of the output sequencer trigger-

out-of-range error check

a. The Mask can apply in any mode of operation, it does not need to only apply to the Sticky bit setting.

b. Adjust VSYNC delay and/or filtering in the SRT block to achieve an hv_skew >= 6 to prevent vsync jitter

sensitivity in the SMUX and SMEAS blocks.

Table 17: SMEAS Register Definitions (Sheet 6 of 6)

Addr

Mode

Bits

Rst

Description

ADE3800 bảng dữ liệu(PDF) 43 Page - STMicroelectronics

ADE3800 bảng dữ liệu(HTML) 43 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL