STMPE2403 datasheet(37/63 Pages) STMICROELECTRONICS

tên linh kiện	STMPE2403

Giải thích chi tiết về linh kiện	24-bit Enhanced port expander with Keypad and PWM controller Xpander logic

PDF	63 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

37 / 63 page

STMPE2403

GPIO controller

37/63

10.3

Hot key feature

A GPIO is known as ‘Hot Key’ when it is configured to trigger an interruption to the host

whenever the GPIO input is being asserted. This feature is applicable in Operational mode

,as well as Sleep mode.

10.3.1

Programming sequence for Hot Key

Configures the GPIO pin into GPIO mode by setting the corresponding bits in the

GPAFR.

Configures the GPIO pin into input direction by setting the corresponding bit in GPDR.

Set the GPRER and GPFER to the desired values to enable the rising edge or falling

edge detection.

Configures and enables the interrupt controller to allow the interruption to the host.

Now, the GPIO Expander may be put into Sleep mode if it is desired.

Upon any Hot Key being asserted, the device will wake-up and issue an interrupt to the

host.

Below are the conditions to be fulfilled in order to configure a Hot Key:

The pin is configured into GPIO mode and as input pin.

The global interrupt mask bit is enabled.

The corresponding GPIO interrupt mask bit is enabled.

10.3.2

Minimum pulse width

The minimum pulse width of the assertion of the Hot Key must be at least 62.5us. Any pulse

width less than the stated value may not be registered.

STMPE2403 bảng dữ liệu(PDF) 37 Page - STMicroelectronics