LD154DRG

T: +44 (0)1322 527 629

E: light@lightgraphix.co.uk

www.lightgraphix.co.uk

Page 4 of 7 | Data sheet issued: 18 June 2026

GLARE CONTROL OPTIONS

/GSHM154

Half-moon glare shield

For applications that require low

glare. Lumen output is typically

reduced by 60% with no light lost

on the lit surface.

/GSOB154

Oval beam glare shield

Reduces the angles at which glare

is visible without compromising

the oval output of the beam.

Useful when used in applications

where glare can be seen from two

sides, for example archways.

/HL

Honeycomb Louvre

Helps reduce glare from all angles

and can be used with glare shields.

/GS154

Glare shield

Standard glare shield, which

provides an excellent balance

between glare control and light

output. This accessory works well

in most applications.

/NGS

No glare shield

No glare shield. Low glare optic

and matt black anodised optic

holder aids in glare reduction.

/HT-154-G Trimless Family Hand tool

Our Trimless family fittings use a hand tool for easy intallation and removal that can be ordered separately. Use the /HT-154-G suction cup or a similar suction tool for the removal of the

fittings from their fixing options. Please contact your LightGraphix sales representative for more information.

How to use the hand tool

Once secured, pull the fitting from its fixing accessory. Apply force vertically to ensure the suction cup does not detach.

When adjusting or rotating the fitting do not use the HT-154-G hand tool to move in situ. Remove the fitting entirely, realign and then place the fitting back into its fixing option.

Note: Rotating the fitting while still in place may result in a comprimised IP seal.

1

2

Place suction cup over the glass

surface and lock in place by pulling

the leaver into a vertical postion.