DIO1413/1414

Version 1.2, Sep 2024

www.dioo.com

© 2024 DIOO MICROCIRCUITS CO., LTD.

31

Bit

Name

Description

7:4

Reserved

Do not use.

3

E3LOW

(DIO1414)

This bit will be set if the measured temperature of external channel 3 drops below the Low Limit for

the programmed number of times in a consecutive measurements.

2

E2LOW

This bit will be set if the measured temperature of external channel 2 drops below the Low Limit for

the programmed number of times in a consecutive measurements.

1

E1LOW

This bit will be set if the measured temperature of external channel 1 drops below the Low Limit for

the programmed number of times in a consecutive measurements.

0

ILOW

This bit will be set if the measured temperature of internal channel drops below the Low Limit for the

programmed number of times in a consecutive measurements.

12.16. Therm Limit status register

The Therm Limit status register indicates if the measured temperature of a certain channel exceeds the Therm

Limit for the programmed number of times in a consecutive measurements. Reading from the Therm Limit status

register will not clear all bits. The THERM status bit in the status register will be set if any of the Therm Limit

status bit is set.

Once any of these bits are set, the THERM status bit in the status register will be set. Reading from the Therm

Limit status register will not clear all bits. When a certain channel Therm Limit status is set, the corresponding

Therm Limit status bits will be cleared when the measured temperature drops below the Therm Limit minus the

Therm Hysteresis. The THERM status bit in the status register will be cleared when all the individual channel

Therm Limit status bits are cleared.

Addr. Type

Register

B7

B6

B5

B4

B3

B2

B1

B0

Default

37h

R

Therm Limit

status

Reserved

E3

THERM

E2

THERM

E1

THERM

I

THERM

00h

Note: R = Read.

Bit

Name

Description

7:4

Reserved

Do not use.

3

E3THERM

(DIO1414)

This bit will be set if the measured temperature of external channel 3 exceeds the Therm Limit for

the programmed number of times in a consecutive measurements.

2

E2THERM

This bit will be set if the measured temperature of external channel 2 exceeds the Therm Limit for

the programmed number of times in a consecutive measurements.

1

E1THERM

This bit will be set if the measured temperature of external channel 1 exceeds the Therm Limit for

the programmed number of times in a consecutive measurements.

0

ITHERM

This bit will be set if the measured temperature of internal channel exceeds the Therm Limit for the

programmed number of times in a consecutive measurements.