ST7FOXF1 datasheet(211/226 Pages) STMICROELECTRONICS

211 / 226 page

ST7FOXF1, ST7FOXK1, ST7FOXK2

Device configuration and ordering information

211/226

Device configuration and ordering information

This device is available for production in user programmable version (Flash).

ST7FOX XFlash devices are shipped to customers with a default program memory content

(FFh).

13.1

Option bytes

The two option bytes allow the hardware configuration of the microcontroller to be selected.

The option bytes can be accessed only in programming mode (for example using a standard

ST7 programming tool).

13.1.1

Option byte 1

Bits 7:6 = CKSEL[1:0] Start-up clock selection.

These bits are used to select the startup frequency. By default, the internal RC is

selected.

Bits 5:3 = Reserved, must always be 1.

Bit 2 = LVD Low Voltage Detection selection.

This option bit enables the low voltage detection block (LVD).

0: LVD on

1: LVD off (default value)

Bit 1 = WDG SW Hardware or software watchdog

This option bit selects the watchdog type.

0: Hardware (watchdog always enabled)

1: Software (watchdog to be enabled by software)

Bit 0 = WDG HALT Watchdog Reset on Halt

This option bit determines if a Reset is generated when entering Halt mode while the

Watchdog is active.

0: No Reset generation when entering Halt mode

1: Reset generation when entering Halt mode

Table 92.

Startup clock selection

Configuration

CKSEL1

CKSEL0

Internal RC as Startup Clock

AWU RC as a Startup Clock

External crystal/ceramic resonator

External Clock

ST7FOXF1 bảng dữ liệu(PDF) 211 Page - STMicroelectronics